Jump to content
Second Skin Audio

Sub Enclosure Help


Recommended Posts

its gonna be real tight everything wise, it would be nice to have an extra~3cubes so you could fit an optimum box

...or just use 3 and throw one in your girls car or something...hint hint

noticed you have individual amps on each sub, sooo grab one more, move your rack a little bit to compensate, do 3 wide which would look ill

38wX24hX14d, port 26 wide, 3 high, 20 deep, gives 1.55cube per sub, 16.8sq in port per cube, 40hz tuning , very close to optimum specs from kicker, use some poly fill if you want lower curve and "smoother response" (port 20wx3hx27l gives 32hz tuning, 13sqin/cube if u wanna tune lower)

may be a consideration, i think 3 across would look better too

Build: http://www.stevemeadedesigns.com/board/ind...hl=avalon+build

monster/rockford/kicker/stinger cables, pioneer source, jbl highs/amps, kinetik/shuriken batts, iraggi alt, dei security, dc subs(atleast for now)

Team DC

Link to comment
Share on other sites

Thanks for your help ray. I was thinking about the 4 10's being on top though. I have to go pick up the other subs right now. PM your email address and I will get back with you later.

James, thats the minimum measurement up top. I could get 16 maybe 17, but I am being conservative. I will be back in a bit.

No matter how hot she is, someone, somewhere, is sick of her shit.

99 Tahoe:

2-10" MA Audio

4-6.5" Kenwood door speakers

Total Amp

Sony HU

Link to comment
Share on other sites

sub back port back probably is going to be loudest, and easiest

and just pm me on here if you want to get back, it forwards to my email anyway

Build: http://www.stevemeadedesigns.com/board/ind...hl=avalon+build

monster/rockford/kicker/stinger cables, pioneer source, jbl highs/amps, kinetik/shuriken batts, iraggi alt, dei security, dc subs(atleast for now)

Team DC

Link to comment
Share on other sites

The kicker amps are running my 4 kicker 6.5's in the doors. I will be using a MTX 6500D for the subs. Right now I am running D4 coils and the amp is seeing 1ohm. The amp plays fine at 1 ohm and barely gets warm, but I have blown both of the 20amp fuses on the amp a couple times. So I'm thinking with 4 D4 coils the amp will be seeing 2 ohms which should stop it from popping fuses.

No matter how hot she is, someone, somewhere, is sick of her shit.

99 Tahoe:

2-10" MA Audio

4-6.5" Kenwood door speakers

Total Amp

Sony HU

Link to comment
Share on other sites

def a good plan, just saying though, if you halve the power and double the cone area, most likely you're going to be right around where you started db wise

p.s. your sig is awesome

Build: http://www.stevemeadedesigns.com/board/ind...hl=avalon+build

monster/rockford/kicker/stinger cables, pioneer source, jbl highs/amps, kinetik/shuriken batts, iraggi alt, dei security, dc subs(atleast for now)

Team DC

Link to comment
Share on other sites

Here you go ray, final measurements. 38L, 22H, 19D(bottom) 13D(Top) Wedge style design. This will allow me more room. What are you thinking?

No matter how hot she is, someone, somewhere, is sick of her shit.

99 Tahoe:

2-10" MA Audio

4-6.5" Kenwood door speakers

Total Amp

Sony HU

Link to comment
Share on other sites

looks good i would have went with this myself but to each there own

cvrs.jpg

R.I.P!

(Nov-29-2009)

92 explorer

- 4 Atomic Apxx 15s duel .7s - 4rth order bandpass wall -4 powerbass XA-3000D's - 16 8volt batts wired to 16 volts - (9+/9-) runs 0gauge - 152.3 Db @ 29hz

current build

97 chevy lumina4 - 1 Atomic Apx 18 - 6 cube slot port trunk sealed off - 1 powerbass XA-3000D - 2 optima G31s in spare tire18 1 run 1/0

Link to comment
Share on other sites

Would the box or port being to big/small cause my subs to pop? It does it on 2,3, or all 4 subs. It's mainly on the low notes.

No matter how hot she is, someone, somewhere, is sick of her shit.

99 Tahoe:

2-10" MA Audio

4-6.5" Kenwood door speakers

Total Amp

Sony HU

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 1118 Guests (See full list)

×
×
  • Create New...