Jump to content

Recommended Posts

I have a 1997 GMC C1500 with the 5.7 motor.

I recently pulled the gas tank to patch a hole. I reconnected the tank and all wires (double checked to make sure wires and hoses were reconnected properly). I go to start the truck and it would rotate but not start.

I pulled the filter and started the pump up and it was pushing gas through the system. I replaced the filter with a new filter. Engine would still not fire.

I pulled the ignition coil and brought it to get tested. It tested out fine and while I was at the auto parts store I picked up a distributor cap and rotor.

Got home and reassembled everything and it would still not fire.

Any ideas?

Link to comment
Share on other sites

Make sure you check all of your fuses.

HU: Pioneer

Highs: 2X 4X6"s, 2X 3.5"s, 4X 5.25" comps, Q-Logic kicks, and a Sundown SAX-125.2

Subs: 4 Nightshade 15s and Strapped SAZ-3500Ds <---Sundown FTW good.gif

Electrical: dual DC Power 320s (ordered) and 2 D3400s up frt and 4 D2700s in the back

.ʇı ɥʇıʍ ʞɔnɟ ʇ,uɐɔ noʎ 'ʞɔıp ǝɹos ɐ ǝʞı1 sı uʍopunS

26d2fe1a.jpg0969b13f.jpg343030b8.jpg

Link to comment
Share on other sites

hmm wires didn't get messed up did they. none are split? and are you sure the pump is good? maybe weak and not pushing enough gas? just a a couple things i'm thinking of. ill ask around see what i can dig up for you

think i isolated the problem down to low fuel pressure. going to pull the pump and check the strainer tomorrow.

Link to comment
Share on other sites

have you checked the pressure with a gauge?

with the key on you should see 60-66 psi, truck on at idle

should be in the high 50's and when you blip the throttle above 60 psi.

center console: lvl 4 12 1.75 cu ft tuned 37htz

alpine cda-9886

dc audio 120.4

infinity kappa 6.5" components

Link to comment
Share on other sites

have you checked the pressure with a gauge?

with the key on you should see 60-66 psi, truck on at idle

should be in the high 50's and when you blip the throttle above 60 psi.

Some are pressurized even higher at idle.... I'd take it to a mechanic and have them to a pressure check on it. I have a 97 astro was the same, It would start with a shot of ether in the intake and run. Wouldn't start when you crank it though. Fuel pump wasn't putting out enough PSI to start or keep it running for long. If it was working before and not working now It may be something simple causing it. Make sure you are getting power to the fuel pump. An there should be a fuel pump fuse/relay somewhere in your vehicle

1993 Chevrolet SWB Pickup

Viper 791XV

Primer Stage

5/8 Static Drop

Kinetik HC1800

Big 3 Knu Flex 0

Team Tex Flex

Link to comment
Share on other sites

might wanna check the ign mod in the bottom of the distributor. u can have it tested at oreillys or auto zone. cost 30 to 50 bucks. could be working but weak

Edited by t-money

2002 ford focus hatch

pioneer DEH-P8400bh

infinity kappa 6.5 components front and rear

XS Power D1200

Shuriken BT-100

audioque 120.4

2 15 inch audioque HDC3 D2

2 audioque 2200d

big 3

mechman 220a alt with external regulator

479-418-3056

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 1803 Guests (See full list)

×
×
  • Create New...