Need some Table Saw Help

[Crump]

I need to get a 60 degree angle. This is what it should look like

What the amps are on, I need at 60 degrees. My saw goes to 45, so idk how im going to accomplish this. Any ideas?

[87accord]

are you trying to cut the piece right under the amp

Edited June 27, 2009 by 87accord

[Crump]

are you trying to cut the piece right under the amp

Yeah just the tip of it so it make it a 60 degree angle

[87accord]

the only thing i can think of it cut it to 45 dreg and sand it the rest of the way but it late so brain is not all on

[Ray]

It can be done but it's not for rookies

if I were u I would just cut the side pieces to

the angle you want then 30 deg the top plate and use a 1/2 roundover

will be nice looking on the top and sit at the correct angle

[Crump]

My design pretty much wont allow me to do that, my dad has been a woodworker for about 20 years and ill ask him, but i need to attach the sides while inside the car so i can run my wires to the amps. and so ill be able to screw the back of the rack into the back of my box. Ill have a build log if im not explaining it right.

[87accord]

ok i can think of only on other way i had to go look at my saw

tak a scrap piece of wood cut it at 30 dreg then take the piece you want for the amp borad that will give you the 60 dregs you need if you i can take some pic for you

[Crump]

ok i can think of only on other way i had to go look at my saw

tak a scrap piece of wood cut it at 30 dreg then take the piece you want for the amp borad that will give you the 60 dregs you need if you i can take some pic for you

Thats what i thought but i have a vertical peice and that would only work for a horizontal piece or top plate, but i just dont have enough space. Cuz then i might as well use a 45 degree angle.

[Crump]

Got a new idea ill try to draw it out quick

[Crump]

pretty much Ray said.

LMK what you think