jonatan Posted July 13, 2009 Report Share Posted July 13, 2009 I have a AQ2200 on a lvl 4xl 15" dual 2 it's all sitting @ .87 ohms and amp plays fine but when I turn it up amp goes into protect mode any idea what's doing this I asked AQ and they said it was ok for amp to go under 1ohm no idea???? I'm clueless Kenwood Excelon DDX812 6.95" double din 4 lvl 4 xl 15" 4 RF 1500 2 RF 600.4 2 15-MC5 - Memphis 5.25" 2 Way MClass Coaxial Speakers 2 15-MC92 - Memphis 6 x 9" 2 Way MClass Coaxial Speakers 2 mc memphis tweeters memphis 16-EQP4 Signal Processors 4 2400 Kinetik 1 1800 Kinetik iraggi 300 http://www.stevemeadedesigns.com/board/ind...showtopic=42009 Link to comment Share on other sites More sharing options...
Deuces D.A.K. Posted July 13, 2009 Report Share Posted July 13, 2009 I have a AQ2200 on a lvl 4xl 15" dual 2 it's all sitting @ .87 ohms and amp plays fine but when I turn it up amp goes into protect mode any idea what's doing this I asked AQ and they said it was ok for amp to go under 1ohm no idea???? I'm clueless are you getting any volt drop? maybe its drawing too much and protecting itself from goin out! just a thought.. Currently Under Construction - hoping to be done by August: JVC KD-SH55 Head Unit Rockford Fosgate 10" HX2 @ 35Hz Hifonics Zeus ZXi6.5C (Mids/Highs) Hifonics TXi4008 (amp for mids/highs) Hifonics BXi610 (amp for sub) KnuKonceptz Kolossus Flex 4 gauge - power/ground 50^2ft. FatMat sound deadener Big 3 - KnuKonceptz 4 gauge 1 Farad Powersonic Cap Yellow Top Optima 150A ANL Fuse Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.