Need Help Port tuning

[Jared420]

Myamp is rated 1470rms@ 14.4v and my volts don't stay there so anywhere from 1100 to 1400 I'll say

according to that chart that's saying I should tune to 50 hz to be loudest? That seems kinda high?

[Marlo Stanfield]

For W3s I'd tune around 32-35hz range if u can fit the port length(once u show the sketches, I'll see if i can figure it all out for ya).

[Jared420]

according to that chart that's saying I should tune to 50 hz to be loudest? That seems kinda high?

Yes 4 dual 2 ohms wired to 1 ohm if I wired to 4 ohms I would be cutting the power to each sub by more than half

[Marlo Stanfield]

wait, so you have 4 dual 2 ohm subs..could you wire them to 4 ohms instead of 1? I think it would make the amp more efficient = less power draw. At least it would help with the dimming of your lights ans stuff.. ha im having a hard time visualizing how the wiring would work for 4 subs

:01nocomment8so:

[barros57]

:01nocomment8so:

im learning, dont worry about it.

and this thing is saying the box needs to be bigger? for 32-35 hz WTF did i do?

[barros57]

god dam this WinISD program. wft I dont get it? does it not even take the port into account when it makes the graph/chart

[Jared420]

For W3s I'd tune around 32-35hz range if u can fit the port length(once u show the sketches, I'll see if i can figure it all out for ya).

it the diameter of the round ports is 3'' or less I will have the space to make them up to like 25'' long if i put them where i want firing out towards the doors