Jump to content
Sonic Electronix

Recommended Posts

Wish I got that lucky, I mean its still loud . But with the trunk open its x2 louder..

Vehicle: 2008 Chevy Cobalt LT

Exterior: Tinted tails, Lowered with Eibach Springs, Black Housing Headlights, 6000k HIDs

Amplifiers: Rockford Fosgate P400-4 & T10001bd

Batteries: Kinetik HC1400

Electrical: Big 3 Stock Alt

Enclosure: 4 ft³ @ 33Hz 75sq.in. of port (18.75sq.in. per cube)

Headunit: Pioneer AVH-P4100DVD w/ 80G iPod

Mids/Highs: Boston Acoustics SL60 (front), Boston Acoustic SX95 (rear)

Subwoofers: 1 15" Fi BL Fully Loaded

Wire: 1/0g KnuKonceptz Kollosus, 4g MobileSpec

Link to comment
Share on other sites

damn! that sucks balls I wish I had an answer for this one. hey its looks good :pardon:

Teamflexissueslong.jpg

06 chrysler 300C Hemi

one mmatts dreadnaut 15 powered by a planet audio vx 2200d

fosgate p200 running planet audio 8" midbass drivers and super compression tweeters

stock battery and a stinger spv44

Irragi 300 amp alternator

big 3 1/0

http://www.stevemeadedesigns.com/board/topic/55075-system-in-my-300c/page__view__findpost__p__763656__fromsearch__1

Link to comment
Share on other sites

damn! that sucks balls I wish I had an answer for this one. hey its looks good :pardon:

Thanks :good:

Vehicle: 2008 Chevy Cobalt LT

Exterior: Tinted tails, Lowered with Eibach Springs, Black Housing Headlights, 6000k HIDs

Amplifiers: Rockford Fosgate P400-4 & T10001bd

Batteries: Kinetik HC1400

Electrical: Big 3 Stock Alt

Enclosure: 4 ft³ @ 33Hz 75sq.in. of port (18.75sq.in. per cube)

Headunit: Pioneer AVH-P4100DVD w/ 80G iPod

Mids/Highs: Boston Acoustics SL60 (front), Boston Acoustic SX95 (rear)

Subwoofers: 1 15" Fi BL Fully Loaded

Wire: 1/0g KnuKonceptz Kollosus, 4g MobileSpec

Link to comment
Share on other sites

Roll around with the trunk open :) j/p, good luck with this.

2001 Bravada (2wd) Pewter on 24's

JVC KW-AV60BT

10 Alpine Type-S 6.5s

2 PSI/BTL 18's @ 32Hz

2 Rockford Fosgate T25001-bd's @ 1-ohm each

Rockford Fosgate T1000-4

Rockford Fosgate T400-4

Rockford 3Sixty.2

Yellow top up front, 2 9a31s in the back

LOTS of AT 1/0

Python 991

350 Amp Singer Alt

"Build Log"

My Facebook

My YouTube

i didnt see the video or read anything but...cool story

and the reason your being a cock tonight is?

Link to comment
Share on other sites

seal the rear deck

R.I.P!

(Nov-29-2009)

92 explorer

- 4 Atomic Apxx 15s duel .7s - 4rth order bandpass wall -4 powerbass XA-3000D's - 16 8volt batts wired to 16 volts - (9+/9-) runs 0gauge - 152.3 Db @ 29hz

current build

97 chevy lumina4 - 1 Atomic Apx 18 - 6 cube slot port trunk sealed off - 1 powerbass XA-3000D - 2 optima G31s in spare tire18 1 run 1/0

Link to comment
Share on other sites

Roll around with the trunk open :) j/p, good luck with this.

Lol ive thought about this.. who needs a trunk lid anyway? good luck to whoever tries and steal this box outta my trunk lol

Vehicle: 2008 Chevy Cobalt LT

Exterior: Tinted tails, Lowered with Eibach Springs, Black Housing Headlights, 6000k HIDs

Amplifiers: Rockford Fosgate P400-4 & T10001bd

Batteries: Kinetik HC1400

Electrical: Big 3 Stock Alt

Enclosure: 4 ft³ @ 33Hz 75sq.in. of port (18.75sq.in. per cube)

Headunit: Pioneer AVH-P4100DVD w/ 80G iPod

Mids/Highs: Boston Acoustics SL60 (front), Boston Acoustic SX95 (rear)

Subwoofers: 1 15" Fi BL Fully Loaded

Wire: 1/0g KnuKonceptz Kollosus, 4g MobileSpec

Link to comment
Share on other sites

I have an idea your not gonna like it cause your goin to have to tear out the foam and the pannels but do that and then make new ones put them in place and dynamat around the whole thing top to bottom overlapping the box and the sheet mettal of car then refoam it here is a pict of mine

032.jpg

Teamflexissueslong.jpg

06 chrysler 300C Hemi

one mmatts dreadnaut 15 powered by a planet audio vx 2200d

fosgate p200 running planet audio 8" midbass drivers and super compression tweeters

stock battery and a stinger spv44

Irragi 300 amp alternator

big 3 1/0

http://www.stevemeadedesigns.com/board/topic/55075-system-in-my-300c/page__view__findpost__p__763656__fromsearch__1

Link to comment
Share on other sites

I did something similar maybe it might help you as well. Anyways what I did was, I made a surround of sorts. Basically it fits snug into the curves of trunk wall. Then I added an other piece to act as a separator. which gave me a flat surface to attach to my box. I put expanding foam in front of this piece where it touch the frame. I then Put my box in and added more foam to seal up where the box and wall meet. I still need to seal off the package tray area but its defiantly better than it was before. Plus this way you can Have the seats up if you got passengers and pull em down if you dont. :P

http://www.stevemeadedesigns.com/board/topic/71075-sojiaraggs9000s-final-box-build/

* Eclipse CD3200 with PAC SWI-CAN2 and SW-ECL2 Steering Wheel Controls Interface
* Pioneer D-Series Mids and Highs ( Fronts: TS-D1702C; Rears; TS-D1702R and Dash; TS-D1002R )
* Rockford Fosgate PBR300X4 ( Mids and Highs Amp )
* DC 3.5k with Dual Inputs; Custom Plexiglass Backing ( Sub Amp )
* Rockford Fosgate Balanced Line Driver

* One FULLY LOADED ~ 10" DC m2 XL
* Custom Built Carpeted Ported Box Tuned to 32hz. Single Chamber With Volume of 1.44618³ ft ; 1.13216³ ft After Displacement
* Custom Built Carpeted Trunk Wall with Added Fans for Amplifier Cooling
* MechMan 240a High Output Alternator

* KnuKonceptz Krystal Kable RCA Cables
* Upgraded Electrical With 1/0 KnuKonceptz Kolossus Fleks Kable and 1/0 Sky High Car Audio Cable
* Five Exide Orbital ORB34M Marine 12 Volt Batteries
* PowerMaster XS D3100 12 Volt Battery

My 2008 Chrysler 300 Limited - SuperCharged 3.5L V6 - UBL

My Old 2005 Ford Taurus - CarDomain - Vehicle Was Sold

Link to comment
Share on other sites

I did something similar maybe it might help you as well. Anyways what I did was, I made a surround of sorts. Basically it fits snug into the curves of trunk wall. Then I added an other piece to act as a separator. which gave me a flat surface to attach to my box. I put expanding foam in front of this piece where it touch the frame. I then Put my box in and added more foam to seal up where the box and wall meet. I still need to seal off the package tray area but its defiantly better than it was before. Plus this way you can Have the seats up if you got passengers and pull em down if you dont. :P

http://www.stevemeadedesigns.com/board/topic/71075-sojiaraggs9000s-final-box-build/

I did almost the same thing, it still slams with the seats up too

¿ǝɯɐƃ ǝɥʇ

Trolls never learn............

All BS aside, If I see one more comment in here that is NOT about the pre-sale, I will start the vacations. And that includes the trolls feeding the trolls.

YOU THE ONE THAT SOUND LIKE A OGER AND HUMPBACK/TROLLS?

Add "SMDLIFER" on Xbox LIVE to play with other SMD members.

Link to comment
Share on other sites

yeah my seats can fold up if I have passengers or if I'm by my self or just another passenger I leave em down

Teamflexissueslong.jpg

06 chrysler 300C Hemi

one mmatts dreadnaut 15 powered by a planet audio vx 2200d

fosgate p200 running planet audio 8" midbass drivers and super compression tweeters

stock battery and a stinger spv44

Irragi 300 amp alternator

big 3 1/0

http://www.stevemeadedesigns.com/board/topic/55075-system-in-my-300c/page__view__findpost__p__763656__fromsearch__1

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 1669 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...