Jump to content

I just bought an Oscilloscope, and I have learned the basics!


Recommended Posts

Unscrew the battery compartment and in the top right corner there should be the words "probe test" with a picture of a squared off wave.

Turn on the scope and place the long lead in the hole making sure it is touching the metal at the bottom. Turn the scope to x10 and the long lead to x10.

Using a flat head screw driver turn the slot(yellow one above the x1/x10 option on long probe) back and forth until you see a squared wave.

Edited by memphisBred

SMD Super Seller/Buyer

Audison----Hertz----Rainbow

Link to comment
Share on other sites

Unscrew the battery compartment and in the top right corner there should be the words "probe test" with a picture of a squared off wave.

Turn on the scope and place the long lead in the hole making sure it is touching the metal at the bottom. Turn the scope to x10 and the long lead to x10.

Using a flat head screw driver turn the slot(yellow one above the x1/x10 option on long probe) back and forth until you see a squared wave.

YAY! Thank you! Wo0t! Pioneer deck doesn't clip til 60/62 :D

Mono amp tuned with 40hz at 1 amplitude.

Doing amp on highs with 1000hz at 1 amplitude.

Please tell me if this is wrong.

| S-10 | 4.5^3 ft | 33Hz | SAE-1000D @ 1 Ohm | 2 SA-12s |

SPL: 143.7 Sealed | 153.4 Port Wars

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 444 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...