bigaltexas Posted October 31, 2010 Report Share Posted October 31, 2010 i currently have a box that aint that good... like. the ports just go down and dont look like a transmission line or nothing, its just one piece of mdf going town like 2/3 of the box on both sides of the box on each port, and no part that runs perpendicular to that or anything.. on the fi website it says recommended port enclosure is Ported box: 3-5cuft | 3-5cuft so... right now im at 8, would i get louder if i made a box 10 cuft for both the subs to go in, or 6 cuft for both the subs to go in? thanks yall... and if anyone knows some good sounding boxes or that are retarded loud like designs and stuff, like ex. transmission line, lemme know. Link to comment Share on other sites More sharing options...
Socky Posted October 31, 2010 Report Share Posted October 31, 2010 Remember once you go bigger box, the easier the sub will move. Smaller, takes more force to move the sub. Id say stay at 8 cubes. Depends on what tuning you are going to be doing. Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell Kenwood H/U 1/0 wire, 136 amp alt 200 ah batteries 12.7 daily 2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts Mb quart 125.4 wired to 4 aura 6's 3.6 cube box tuned to 36 plays down to 23hz Link to comment Share on other sites More sharing options...
bigaltexas Posted October 31, 2010 Author Report Share Posted October 31, 2010 so like... say if i went 10 ft, what tuning would i want to be loudest as i could... and thanks for the reply man.. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.