kbreudi

!!!!! Um kinda hard to understand what your asking my man.

149.9 with one 15 and 2000k RMS? I need some pics to beleive that man

I would isolate everything and lay on a peace of wood just the mobo with cpu and ram and power supply. Short the turn on pins and see i the cpu fan starts and listen for peeps. Then add the video card and keep going untill you run into problems. If nothing happend with the bare mobo, cpu and ram try just cpu and mobo, see if you get beeps or if cpu fan turns on. Try different PSU even if you have a new one. Be sure the extra 12v for the mobo is plugged in from the psu as well.

Tis very true steve, im sure we would have the same results with any clean 3000 watts. Its mainly the way the box and car is set up along with the great woofers.

I was so shocked first run full tilt with the one amp, started at a 148 and change. Im glad you decided to film it, show all the hatters what only one sundown can do. Well we have to see what happend with 4 times the power once we get the other amps back in this week

Got my last final in exactly 9 hours and 56 minutes then no classes all summer!!!! i smell some free time with car audio comming lol...ill post grades when they come

haha now you need to upload the video of sodapop kid winning it lmao

Pics or it didnt happen J/k i was there, nice job man i just wish i didnt have to rip out one of my amps an hour before my run

same power same electrical, half the cone area? Yea it will be about 2-3Db SOFTER

http://www.termpro.com/asp/members2.asp?Wh...p;MemberID=9988

Maxxsonics is the parent company for MB Quart, Hifonics, Crunch and Autotech. The Hifonics line hs the best amps out of the four IMO. But as stated the new crunch GP3000 is deff a good amp for the price. A Autotech4000 is also a decent amp if you can get one

well the subs will not fit facing bck, and the port facing up probably wont have the best results....this is just the first of a few boxes for these subs, amps and trunk. probably one with subs and ports facing into the cabin sealed from the trunk, should touch a 150 from that and it will still be a trunk setup. Trust me the is NOT the best desgin for a trunk, we just made a quik box to test with even though the subs are choked off

right now i have 4 batterys and stock alt, my 240 amp rebuild is sitting right here waiting to be put in. Right now i see between 11.8 and 12.3 at the WORST drop, once the alts in it should get louder too

deff dude, the first show of the season is THIS sunday at advanced mobile toys, gonna be a big turn out hopefully ill see some smd guys there

Heres just a couple pics of the box, ill have pics of amps and another vid tomarow when i go to ss audios and ill use his camera

Quik little vid of my new setup right afte rit got done. The amps just got installed 5 min before the vid was taken, so i didnt have it up to high Rember this is a trunk setup so its not bad for what it is

You have heard them before? What model eclipce is that than? They are actuacly pretty decent subs. SS Audio could probably tel you more about them

Well if he was to do a silly thing like that, it would be WAY to hard and complicated to "match" both amps so that both coils would see EXACTLAY the same power and signal. You could easly fuck the coils if you do it wrong....also if he was to to that, each coil is 2 ohms, so you would see 2 x the power the 1500 does at 2 ohm.....now if he was to seriece the coils to get 4 Ohms, then strap 4 Ohms each amp wouls also see 2 ohms just like the one amp per coil....so there would be absolutly no point at all to do what you said

first parallel the two coils on your dual vc woofer...then you will have two leads from the woofer, one + and one - with the sundowns just "bridge" the negative terminals of the amps to each other, and connect the + wire of the speaker to the + terminal on the master amp. then the - speaker wire to the + on the slave amp. be sure to have the RCA's ret right for straping amps

NOO dont do that.....Just parellel the coils to 1 ohm and strap that to the two amps....each amp will do about 1800 or so watts rms at .5 Ohm at each amp

Its tuned to 88Hz with 22 sq" of port

never mind you obvoisly didnt understand me. No one said you were cheating or thats its a big deal. But what IS a big deal is 10k watts and a 18v set up, not something you see everyday. Just figured you were either joaking about not know what dbdrag is OR you dont really have the setup in your sig....if both are wrong than damn you better get out to those lanes and kick some ass!

you have 10k watts on a 18 volt set up and you dont know what db drag is? HMmmm something sounds fishy

http://www.stevemeadedesigns.com/board/ind...showtopic=19952

well if its brand new, never had any speaker wires or RCA's connected, hooked up right, turned on and went right into protect its 99% likely a bad amp. Just check to make sure you are getting at least 12v at the amp power terminals as well as the remote wire....probably gonna have to send it back