MIKE-2U

By the pictures only! I would go with the nissan just looks sporty which being young i like. I have no experience with any

Whatever will sound best I will go with

If i went wider would that help?

If i went wider would that help?

I wondrr what the differece in the one you made to the one in this post would be

Nope i am just comparing all the designs but looks like im going with the one you made. Pm me a little later i am still un clean on the length of that piece, As i am mobile now.

Any od you still have plans for them?

I want to be able to take it out in need of spare tire. And if it can be built wider than ok i just threw dimensions of my old box

Its not to much power as long as its clean. I have ryan on this as well and i am just getting a collection of designs then i will build.

http://www.caraudioclassifieds.org/forum/mono-amplifiers/116898-fs-dc-audio-5-0k.html#post1598264 your welcome

Huh? well what is your box tuned to ? Edited: why would you want it to hurt to listen to ?

edited

IB4L

I need a new box design. For a Pontiac g6 with 2 sa 10s off a aq 2200D at 1 ohm or .5 ohms. this is for daily use. I would like to get it as loud as possible but still sound good. tuning i think should stay between the 28 - 35 hz mark. not sure on vehicle peak freq at. max dimensions are Height- 15 Width- 30 Depth- 17 sketch ups would help too thanks!

Pontiac g6

Is this going to happen this year ? I'm In Stillwater, Minnesota and would like to attend. My Daily Driver wouldn't compete but it would be fun to go.

thats what i would if i had to order again, but even tho i ordered 0g it hasnt giving me a problem with my system alright sounds good thankyou

So i should use the OFC and i want 1/0 so i should get 2/0 ?

one shipped to 55082

Well i noticed everyone was using welding cable so in the event i switch up i may also make the switch to welding cable. I just want to clear up so concerns i had first. 1. can you mix welding cable and normal car audio wire ? 2. what kind does the wire have to be ( cca, ofc, etc) ? 3. where can i get it ? 4. advantages to using this over the Knu konceptz wire or another company ? 5. what sort of connectors can i use on it ? 6. does it just replace the power and ground wires , or do they also have 8 gauge welding cable for speaker wire ? 7. anything else i should know about it ? thanks in advance.

Thanks man

Thanks!

I didn't know if it was the same ray as the SMD Ray, and i commented on it .

The first song, some sort of dubstep ?