Jump to content
DC Sound Lab

Another dc question


Recommended Posts

I bought a dc xl 15 d1 and want to put 3krms at 2 ohm on it for comps and then turn the gains down for daily play. Will this hurt the sub?

It will be in a 3.8ft3 tuned to 33hrts with 53in2 of port

I havent bought the amp yet. A guy told me that if I run the sub at .5ohm into one of my re xt4000d amp as the sub moves it will increase the ohm load to around 1.2ohm. Sounds sketchy to me so Im not sure that I really want to try this out.

Since were all having a moment of truth.

I hate country too..

I'd only listen to it if I got some hotass bitch in my car and shes gonna suck my dick.

Link to comment
Share on other sites

the sub can take 3k as long as you dont clip at all. i dont recommend you running at .5ohm.

If I answered you in a well mannered, informative way, you asked a good question or had a good attitude. If I was an asshole, you asked a stupid question or you had a fucktard attitude... or I was in a bad mood.

Team BassickHU: Pioneer AVIC Z110Front: Peerless SLS 6.5", Peerless HDS 4", Rainbow tweeter - running activeAmp: JL HD600/4 and DC 4 channel (bridged to midbass)Processor: JBL MS-8Subs: 2x 12" AA MayhemsAmp: DC 3kElectrical: DC power 270xp alt. 1/0 big 4. XSpower D3400 and six D680s.

http://www.stevemeadedesigns.com/board/topic/121795-29-update-the-buick-is-getting-a-rebuild/

Top career scores: DBdrag 151.7 MECA SQ 82.25My SOTM build

Yeah. im pretty sure they dont warranty retarded people.

Link to comment
Share on other sites

I will tune the amp so it doesnt clip and then leave it along and use my bass knob to turn the gain up and down from daily to comps.

But when I scope the amp and tune to under clipping can it still clip with poor quality music?

Since were all having a moment of truth.

I hate country too..

I'd only listen to it if I got some hotass bitch in my car and shes gonna suck my dick.

Link to comment
Share on other sites

some songs do have clipping in them, yes. some are recorded that way and there is no version of that song you can get without clipping. its best to only REALLY hammer on songs you know. of course anything decaf has made will be safe.

If I answered you in a well mannered, informative way, you asked a good question or had a good attitude. If I was an asshole, you asked a stupid question or you had a fucktard attitude... or I was in a bad mood.

Team BassickHU: Pioneer AVIC Z110Front: Peerless SLS 6.5", Peerless HDS 4", Rainbow tweeter - running activeAmp: JL HD600/4 and DC 4 channel (bridged to midbass)Processor: JBL MS-8Subs: 2x 12" AA MayhemsAmp: DC 3kElectrical: DC power 270xp alt. 1/0 big 4. XSpower D3400 and six D680s.

http://www.stevemeadedesigns.com/board/topic/121795-29-update-the-buick-is-getting-a-rebuild/

Top career scores: DBdrag 151.7 MECA SQ 82.25My SOTM build

Yeah. im pretty sure they dont warranty retarded people.

Link to comment
Share on other sites

Ok, good to know. I will just watch what I play and keep my gains down low for daily music..

I think rather than chance the life of my amp I will just buy the new amp I was looking at. This way I will have plenty of power for sub upgrades later on.

Thanks for the help

Since were all having a moment of truth.

I hate country too..

I'd only listen to it if I got some hotass bitch in my car and shes gonna suck my dick.

Link to comment
Share on other sites

the sub can take 3k as long as you dont clip at all. i dont recommend you running at .5ohm.

why wouldnt you recomend running at .5 ohm?

if he had a 1ohm stable amp, and good power supply, run it at 2ohm daily, and 0.5 for burps in competition.

as long as the amp is getting enough power it will be fine. after box rise etc it will be geting more than 0.5 any way.

my amps run daily at 0.7 and are fine.

not saying you are wrong/arguing with you, just asking a question :)

Link to comment
Share on other sites

the sub can take 3k as long as you dont clip at all. i dont recommend you running at .5ohm.

why wouldnt you recomend running at .5 ohm?

if he had a 1ohm stable amp, and good power supply, run it at 2ohm daily, and 0.5 for burps in competition.

as long as the amp is getting enough power it will be fine. after box rise etc it will be geting more than 0.5 any way.

my amps run daily at 0.7 and are fine.

not saying you are wrong/arguing with you, just asking a question :)

i can usually tell by the question, the persons experience level and i give an answer based on that. going to half ohm means seriously pushing the limits of your equipment and you need to be ok with blowing something up. I dont think the OP is at that stage.

so while battling imp rise with a low nominal load is the correct answer for some people (i was doing it myself) its not the answer for everyone.

If I answered you in a well mannered, informative way, you asked a good question or had a good attitude. If I was an asshole, you asked a stupid question or you had a fucktard attitude... or I was in a bad mood.

Team BassickHU: Pioneer AVIC Z110Front: Peerless SLS 6.5", Peerless HDS 4", Rainbow tweeter - running activeAmp: JL HD600/4 and DC 4 channel (bridged to midbass)Processor: JBL MS-8Subs: 2x 12" AA MayhemsAmp: DC 3kElectrical: DC power 270xp alt. 1/0 big 4. XSpower D3400 and six D680s.

http://www.stevemeadedesigns.com/board/topic/121795-29-update-the-buick-is-getting-a-rebuild/

Top career scores: DBdrag 151.7 MECA SQ 82.25My SOTM build

Yeah. im pretty sure they dont warranty retarded people.

Link to comment
Share on other sites

the sub can take 3k as long as you dont clip at all. i dont recommend you running at .5ohm.

why wouldnt you recomend running at .5 ohm?

if he had a 1ohm stable amp, and good power supply, run it at 2ohm daily, and 0.5 for burps in competition.

as long as the amp is getting enough power it will be fine. after box rise etc it will be geting more than 0.5 any way.

my amps run daily at 0.7 and are fine.

not saying you are wrong/arguing with you, just asking a question :)

i can usually tell by the question, the persons experience level and i give an answer based on that. going to half ohm means seriously pushing the limits of your equipment and you need to be ok with blowing something up. I dont think the OP is at that stage.

so while battling imp rise with a low nominal load is the correct answer for some people (i was doing it myself) its not the answer for everyone.

aahhhh ok cool. was just wondering is all :)

altho im not ok with blowing anything up i still run under impedence, but keep an eger eye on volts and how hot stuff gets :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 609 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...