first impression when you hear this..

[Relyks]

4 ga wiring ( 4ga big 3 )

sony headunit (4v pre amp 3 pre out )

AudioQue 1200.1 D amp ( wired at 2ohm )

AudioQue SD 2.5 D4 10" sub

1.67cu.ft box ported and tuned at 33hz

Crescendo Audio new 6 1/2" componets.

whats first thing comes to mind good bad? i dont care speak your mind

[831Arevalo]

its decent !! is it a budget build? try to use 0 gauge if you can instead of 4 gauge ,just my to 2 cents

[Relyks]

actually not a budget build really just i have been doing this overtime

and to be honest last ear when i joined this site here my old system specs

sony headunit (2 pre out )

4ga amp kit

400 watt spl amp

10" kicker comp in 1.00 cu.ft

boss 3 way componet set

i hated it....

this is my new system and i am going to get 0ga soon but im buying a xs 3100 battery first then some 0 /1 ga to run the big 3 and amp.

[C-Fizzy]

its decent !! is it a budget build? try to use 0 gauge if you can instead of 4 gauge ,just my to 2 cents

The amp has 4guage inputs. Why would he need 1/0.

[DannyV18]

Sounds like a good system. Plan on putting an amp on those crescendo mids?

Don't waste your money for 1/0 on that amp, especially since you have it wired to 2 ohms. Same goes for the big 3.

[Relyks]

i plan to get AudioQue 4x90 amp for them mids soon....

im in love with the AQ amps (:

Edited April 17, 2011 by Relyks

[DannyV18]

High quality 4 gauge would be enough for both amps.

[Relyks]

knukoncept wiring.

[831Arevalo]

its decent !! is it a budget build? try to use 0 gauge if you can instead of 4 gauge ,just my to 2 cents

The amp has 4guage inputs. Why would he need 1/0.

im talking about the big three not amp

[fritosaregood]

you can never over do wiring, especially when youre most likely gonna upgrade. most of the stock wires in a car are close to 4 gauge too, so the big 3 should really be in 0 gauge.