Seem about right?

[Swaggasaur]

any one want to suggest how i would support the aero ports? would i just put a piece of would below them with a semi circle cut out?

make like legs with 2x4's under the aero port to keep it up then glass it together?

[Autruche]

making port braces is easy, you can do it two ways.

1) make a small block and screw it to the box, and screw it to the inner port flare.

2) make a piece of wood with a circle cut out that you can slide the port through, and glue it to the bottom of the box. make sure it fits tightly around the port though.

[bre2ts]

something like this?

[bre2ts]

or like this?

[bre2ts]

or this?

[Swaggasaur]

Exactly. Nice sketchup skills btw

[bre2ts]

Exactly. Nice sketchup skills btw

thanks, i just started to really use it 2-3 days ago... i particularly like the last one the best

[Swaggasaur]

Exactly. Nice sketchup skills btw

thanks, i just started to really use it 2-3 days ago... i particularly like the last one the best

yea that one will be easier to make too.

nice setup, i see in your sig.

have you got metered?

[bre2ts]

i will be building in june, have been aquiring everything during deployment

Edited April 19, 2011 by bre2ts

[Autruche]

Yes, just like that, just make sure you go all the way around the pipe if you brace it around the pipe, or go all the way around the flare so you can secure it all the way around, an make sure to round the top so your port bracing has minimal interference with moving air.

Like so: