ohm load question

[mzenon88]

alright so i want to run six 4 ohm components to a single rf 400.4.

exactly how do i run 6 sppeakers to a an without getting below a 2 or 4 ohm load id prefer to get a 2 ohm load for power reasons but am open minded

[MrSkippyJ]

i would parallel 2 on a set of channels (front for example) and run a single component to the other set. That would give you 2 ohms on 2 channels and 4 ohm on the other channels.

[bassinblazer]

You will have to wire them as if you were thinking about them as 3 dual 4 ohm VC speakers. Instead of individual VC speakers. It is going to get a little hairy, but something like this would probably do. You are going to be pushing close to 2ohm...

[bassinblazer]

You could run 4 speakers off of two channels and 2 off the other 2...that would work..../\ he said it!

[mzenon88]

i would parallel 2 on a set of channels (front for example) and run a single component to the other set. That would give you 2 ohms on 2 channels and 4 ohm on the other channels.

that makes alotof sense because 4 are rear stage and two are front stage