Socky Posted June 20, 2011 Report Share Posted June 20, 2011 Never broken anything in, the day I get the subs is normally the hardest I'll play because im so excited lol..never had to recone a sub, and I always run over Rms, maybe I'm just lucky.. *knocks on wood* Quote Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell Kenwood H/U 1/0 wire, 136 amp alt 200 ah batteries 12.7 daily 2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts Mb quart 125.4 wired to 4 aura 6's 3.6 cube box tuned to 36 plays down to 23hz Link to comment Share on other sites More sharing options...
ISO Posted June 20, 2011 Report Share Posted June 20, 2011 I never said the Kickers got louder....They got lower and just had an overall better sound to them. Quote Isobaric - Refers to the practice of coupling two drivers together to make them act as one. "Giving up doesn't always mean you are weak; sometimes it means that you are strong enough to let go." Insanity: doing the same thing over and over again and expecting different results. The Destruction of a person builds character. Link to comment Share on other sites More sharing options...
TheNewbie Posted June 20, 2011 Author Report Share Posted June 20, 2011 Well seeing how this thread is still popular haha, i have another question im about to get the 2k amp to 2 lvl3 dc's put about 800 watts each hopefully, i guess the shop will set it till it doesn't distort so i really don't have any say in how many watts goes to each, but all i have to do is bridge the amp right? Since it is a mono amp. And put the amp to a one ohm load? Quote Check out my build log: http://www.stevemead...60#entry1958353 Different folks have different strokes. Link to comment Share on other sites More sharing options...
BJD3 Posted June 20, 2011 Report Share Posted June 20, 2011 Well seeing how this thread is still popular haha, i have another question im about to get the 2k amp to 2 lvl3 dc's put about 800 watts each hopefully, i guess the shop will set it till it doesn't distort so i really don't have any say in how many watts goes to each, but all i have to do is bridge the amp right? Since it is a mono amp. And put the amp to a one ohm load? You can't bridge a mono amp. There aren't multiple channels to bridge. Go to the12volt.com and click the subwoofer wiring diagrams, input your sub's configuration, and follow the diagram. Quote Anti Peel and Seal...lol You may be offended by the above. Don't take it personally, I'm just abrasive. 2002 Buick Park Avenue DC Level 4 M2 12 D2 Car Audio Bargain 1600.1 Eclipse CD3200 ~2 cubes @ 34 hz. Stinger Roadkill Expert Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.