noob question wiring subs to amp

[BackwoodsBumper]

looking for a .5OMH outof my two DC 2ohm duals into my DC 1.2K do i bridge them both to get .5ohm or do I have to hook each one to a channel?

[-Hobby-]

Wire all the positives together and all the negatives together to get a .5 ohm load at the amp.

[BackwoodsBumper]

the amplifier has 2 channels though 2 swets of +/- or a bridge... on the graph on the manual it shows 2 speakers plugged into each channel to get .5ohm but on my AudioPipe I just plugged them in bridged im confused... so I just parallel them all and bridge?

[graham0599]

Check this out

http://www.the12volt.com/caraudio/woofer_configurations.asp~Q~2~I~22

[-Hobby-]

Either way will work

1 ohm to each channel or bridged to .5. Thats if the amp is stable to those loads.

[-Hobby-]

double post edit

[dohckiller808]

That amp is internally mono. Those 2 outputs are not a stereo signal.

[BulletInjection]

Yeah, just be careful when you first do it and make sure your voltage isn't dropping lowwwww and that your amp can handle the low load.

edit: I am a noob, he said it was a DC 1.2k