Dbforlife Posted March 15, 2012 Report Share Posted March 15, 2012 4 channel amp going into protect unless i unhook 1 speaker. Maybe it was luck of the draw that maybe that 1 channel is done and i disconnected the right speaker? But its been happening every since i put it in my blazer now and im running a clarion eq now with a strong preout. Not just running the 4 channel off the deck anymore. Any ideas? or what to check? Or should i just chuck it and buy a new one? 1998 GMC Jimmy 4 Dr. -SINGER 275 Amp Alternator -150 FT. Of 1/0 OFC (8 runs) 4 pos, 4 neg. Front-back. -Audioque AQ2200D @ .5 ohm -2 Audioque HDC3 18's Tuned to 27-29 HZ -4 Clarion 6.5's -2 Optima yellowtops Link to comment Share on other sites More sharing options...
2loud4uboyz Posted March 15, 2012 Report Share Posted March 15, 2012 Try running a wire off that channel that's acting up to a speak . See if it plays. Could have a bad wire. Link to comment Share on other sites More sharing options...
BFF Larry Posted March 15, 2012 Report Share Posted March 15, 2012 what about how you wired the speakers? too low of final imp.? Team Clearly Louder (MECA)Team DC Audio ++* SELLING the CACTUS SOUNDS K12 for $1550 shipped *++ HMU!!! 3 flips. nollie flips. big flips. hardflips. - steez Youtube Channel My Build Log 95 Bonneville SSE - WALLED/4th Order - ~30 cubes - *thanks LoganBerry, CortezDVT, Cj18, SuperCharged DC, Ryan-RAM Designs,LoudNLow931* Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.