SpawnZ Posted May 24, 2012 Report Share Posted May 24, 2012 I purchased an old Memphis 16-ST300.4 off of my friend from Georgia for a home system build. Unfortunately it wont turn on. I'm hoping someone can look at these guts and find something obvious I'm missing. Link to comment Share on other sites More sharing options...
Kyblack76 Posted May 24, 2012 Report Share Posted May 24, 2012 before i went that far, did you meter, or check and verify your in coming V was ok??????? SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold Link to comment Share on other sites More sharing options...
SpawnZ Posted May 24, 2012 Author Report Share Posted May 24, 2012 Yes, the voltage was fine. Link to comment Share on other sites More sharing options...
Kyblack76 Posted May 24, 2012 Report Share Posted May 24, 2012 Remote as well???... If all that was good to go,... It's beyond me...no way I can look at a board pic and say "oh! There's your problem" Good luck bro., SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold Link to comment Share on other sites More sharing options...
KillaCam Posted May 24, 2012 Report Share Posted May 24, 2012 At the bottom of the 2nd pic looks like some solder was dripped on the board. And the fact more than one person agrees does not make it a circle jerk, it makes it a bukkake scene and you're in the middle Chick took 3 shots of Jager, and then, pissed in my mouth.. B5 Passat Build Log Link to comment Share on other sites More sharing options...
SpawnZ Posted May 24, 2012 Author Report Share Posted May 24, 2012 Remote as well???... If all that was good to go,... It's beyond me...no way I can look at a board pic and say "oh! There's your problem" Good luck bro., I'm aware, I was just wondering if there was anything obvious out of place. Thanks though. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.