How to wire below 1 Ohm?

[lt1jerome]

How do I wire my setup so my amp sees a .5 ohm load? My setup is two 9515's and two bc3500's. One amp on one sub wired at 1 ohm. I belive my electrical can support the .5 plus im in the process of upgrading that also. Thanks for any advice.

[tacomaguy1]

What coil configuration are each sub

[Miguels]

what is the ohm load on the sub? is it dual 1 ohm or dual 2 ohm

[lt1jerome]

Dam....Cant belive I left out the important info. Each sub is dual 2.

[Miguels]

[Miguels]

what amp do you have and when you say you have the electrical to run .5 what exactly do you have?

[tacomaguy1]

Wire them together to 2 ohms and strap the amps. Strapped at 2 ohms, each amp wil see 1 ohm

[lt1jerome]

I looked on the 12 volt website but I could only find the diagram to wire down to 1 ohm. Currently I have the big3, Mechman 320 w/ adj regulator set at 14.8. D3400 under the hood, two D3100's in the back and zero ga power ground. Next purchase will be another mechman 320

[lt1jerome]

amps are crescendo 3500's

[tacomaguy1]

Or you can wire to .5 and strap the amps, each amp would see. 25

I wouldn't recommend it though lol

Or one amp on each sub at 1ohm