christamez80 Posted September 11, 2013 Report Posted September 11, 2013 My amp kicked into protection all of a sudden. I have 2 DC Audio 2.0k's and they are strapped at 2ohm. They have been playing fine for 2 weeks. They master went into protection, the other is fine. I unplugged the ground and unplugged the rca's, then plugged ground back and it stays on. When I plug in the rca's it goes back to protection. Could it be bad rca's or a bad signal inside amp toake it kick into protection? Voltage isn't an issue. I have a mechman 270 and 2-XS D3100 and a xs d925 up front.
EricDoody95 Posted September 11, 2013 Report Posted September 11, 2013 My amp kicked into protection all of a sudden. I have 2 DC Audio 2.0k's and they are strapped at 2ohm. They have been playing fine for 2 weeks. They master went into protection, the other is fine. I unplugged the ground and unplugged the rca's, then plugged ground back and it stays on. When I plug in the rca's it goes back to protection. Could it be bad rca's or a bad signal inside amp toake it kick into protection? Voltage isn't an issue. I have a mechman 270 and 2-XS D3100 and a xs d925 up front. check all the grounds, see if there is any bad connections or corrosion. 2003 Honda Element Pioneer DEH-9400BT Big 3 XS Power D5100 Sky High CCA (2 Runs 1/0 Gauge) 2 XS Power D3100s 1 DC Audio 3.5k @ 1ohm. 2 DC Level 4's w/ XL Softies Custom Box tuned to 29hz CT Sounds 125.4 2 Sets of CT sounds Meso Components *North East Frequencies*
christamez80 Posted September 12, 2013 Author Report Posted September 12, 2013 Found the problem. It was a loose wire. Made sure everything else was nice and tightened.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.