christamez80 Posted September 11, 2013 Report Share Posted September 11, 2013 My amp kicked into protection all of a sudden. I have 2 DC Audio 2.0k's and they are strapped at 2ohm. They have been playing fine for 2 weeks. They master went into protection, the other is fine. I unplugged the ground and unplugged the rca's, then plugged ground back and it stays on. When I plug in the rca's it goes back to protection. Could it be bad rca's or a bad signal inside amp toake it kick into protection? Voltage isn't an issue. I have a mechman 270 and 2-XS D3100 and a xs d925 up front. Link to comment Share on other sites More sharing options...
EricDoody95 Posted September 11, 2013 Report Share Posted September 11, 2013 My amp kicked into protection all of a sudden. I have 2 DC Audio 2.0k's and they are strapped at 2ohm. They have been playing fine for 2 weeks. They master went into protection, the other is fine. I unplugged the ground and unplugged the rca's, then plugged ground back and it stays on. When I plug in the rca's it goes back to protection. Could it be bad rca's or a bad signal inside amp toake it kick into protection? Voltage isn't an issue. I have a mechman 270 and 2-XS D3100 and a xs d925 up front. check all the grounds, see if there is any bad connections or corrosion. 2003 Honda Element Pioneer DEH-9400BT Big 3 XS Power D5100 Sky High CCA (2 Runs 1/0 Gauge) 2 XS Power D3100s 1 DC Audio 3.5k @ 1ohm. 2 DC Level 4's w/ XL Softies Custom Box tuned to 29hz CT Sounds 125.4 2 Sets of CT sounds Meso Components *North East Frequencies* Link to comment Share on other sites More sharing options...
christamez80 Posted September 12, 2013 Author Report Share Posted September 12, 2013 Found the problem. It was a loose wire. Made sure everything else was nice and tightened. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.