bassman619 Posted September 16, 2013 Report Share Posted September 16, 2013 I have a memphis mc4.75 4 channel amp.. I am getting a set of re audio xxx 6.5 components. They take 150w rms and 300w peak each but thes comps are 2 ohms impedance. I have this in my car now hooked up to some mclass 6.5s and I have done research on this amp. What I found is you can bridge the amp to get 2x 230watts rms at 4 ohms. Youcan also put a 2 ohm load on each channel to get a 4 x 115w rms..but what I want to do is bridge it but I dknt know if that is possible with this amp and speaker combo. Can some one tell me if it can be done? You need trunk space to get groceries and shit...bitches love groceries Link to comment Share on other sites More sharing options...
STEvil Posted September 16, 2013 Report Share Posted September 16, 2013 see other thread, and dont post multiple threads.. MickyMcD - "Capable of making some serious trouser flapping volumes at where's-my-testicles frequencies, the Servo-Drives used to be fairly jaw dropping..." Any time you have have a power wire next to your frame put some rubber hosing (or cut up an innertube) around it. The wire is bound to wiggle (due to driving or flex) and the casing will eventually wear through. Hammerdown... 1% no links to outside websites, business related FB/YT pages allowed. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.