David Mears Posted December 1, 2013 Report Share Posted December 1, 2013 What is the difference of getting 2 hifonics 2500 rms amps for 300$ each vs a 5000 rms amp at 1,000$??? Can u do either or ? Link to comment Share on other sites More sharing options...
Tecomah Posted December 1, 2013 Report Share Posted December 1, 2013 Hifonics aren't the best quality. 750??! Yeah, fuck that. Fuck this website, fuck SMD, fuck Steve, fuck all of his butt buddy mods, and their couches.^ DON'T BE A DICK LIKE THIS GUY Team Subsonic Lows Link to comment Share on other sites More sharing options...
David Mears Posted December 1, 2013 Author Report Share Posted December 1, 2013 I have a colossus 3200 and as long as it's at 14.4 it does rated power lol Link to comment Share on other sites More sharing options...
David Mears Posted December 1, 2013 Author Report Share Posted December 1, 2013 Is it the same type of power or does the 2 amps draw more current? Link to comment Share on other sites More sharing options...
DubNDodge Posted December 1, 2013 Report Share Posted December 1, 2013 all hifionics amps aren't that efficient. But I guess if you already have it, run it. '01 Dodge Stratass Sealed Trunk Build Log 2008 Honda Fit Sport Build Log On 10/3/2013 at 10:00 AM, ROLEXrifleman said: Anyone who says they knew everything they wanted out of life at 19 can go suck a bag of dicks cause they are lying to themselves or brought up in a cult. Link to comment Share on other sites More sharing options...
David Mears Posted December 1, 2013 Author Report Share Posted December 1, 2013 I have the stock battery up front but a kinetic hc 2400 and hc 2000. A run of actual zero gauge. And will have a stock 150 amp alternator and will upgrade to a 250 amp. So I should be getting good voltage from it. It's gonna power 2 fi fully loaded bls in an suv at 32,4 hz. Is this a decent system? Link to comment Share on other sites More sharing options...
David Mears Posted December 1, 2013 Author Report Share Posted December 1, 2013 I've never had any other system except 2 cvrs in a junky prefab sealed box and then a solo x in the backseat which wasn't loud. I could out the solo x 18 in the explorer but I hear 2 bls get loud so I did that instead this will be my first real spl system Link to comment Share on other sites More sharing options...
Jessica Posted December 1, 2013 Report Share Posted December 1, 2013 Running a single big amp or two smaller amps is kind of hard to compare because in theory they could actually put out different power full tilt. What i mean is, say brand "X" 1500.1 does 1650 @ 1ohm, but the same brand's 3k does 2.8k @ 1 ohm. But brand "Y" 1500.1 does 1500 @ 1ohm and the 3k does 3500 @ 1ohm. Other things to consider are some brands of amplifiers are made cheaply and even amp to amp you can see a broad range of power output, using two cheap amps you will have to match output with the lowest output amp. You also have to take into consideration the efficiency of the smaller amps vs the bigger amps. The smaller amps may have a higher efficiency rating the bigger amp or vice versa. So using a lower efficiency amp(s) will put more strain on your electrical. Then there is cost point, How much are you paying per watt when buying two vs buying one. Dont forget, two smaller amps will need more wire, more connections, and you will have to make sure the crossovers and gains are matched. Another thing is the ohm load the amps will see. If you have two dual 4 ohm subs and you use two amps, you will only be able to wire each amp to 2ohm whereas with one amp you can wire down to 1ohm. Unless of course the two amps are strap-able. So i know i didn't say which is better, but no one will be able to tell you. This is one of those things where you have to test it to see. Some guys have gained from multiple amps, some from single. Some have gained from strapping, some have gain by not strapping. I've even seen some lose output by throwing more power at their subs when overpowering. Rest in peace, walled 87 accord build log 03' Corolla build with AA Mayhem inside. My super random youtube channel and terrible camera work. Wiring comparison by CaptainzPlanetz Wire and fuse guide by Guest SyKo13 Link to comment Share on other sites More sharing options...
TRON Posted December 1, 2013 Report Share Posted December 1, 2013 It all depends on the amplifier. If you have two 2500w amplifiers that can be strapped, then that would be just as good as a single 5000w amplifier. You can run two amplifiers that are not linkable (daisy channing) but the risk of sending different power levels to different drivers is something to consider. You can set up dasiy chainned amplifiers to output the same power but you need the proper tools for that, which can be pricy. When it comes to running multiple amplifiers for multiple drivers, I would rather spend the extra money to get linkable amplifiers rather than daisy channing cheap ones. Or just buy one 5000w amplifier...easy. AND: When it comes to buying amplififers, generally the more you spend the better you get. Avalanche Alpine Type S comps Alpine Type S 10'' Alpine MPR-F300 Alpine MRX-M50 Mechamn 270 XS Power d3400s Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.