Chao Cox Posted February 11, 2014 Report Posted February 11, 2014 Hi, I am a newly registered SMD forum user, but I've been on tons of times. Finally decided to create an account, mostly to ask a question abou this amp I am about to get (arc audio SE 4000). I have had a a few amps (massive audio n4, jl 1000/1 v2, JBL GTO 1201.1ii) and none of these have had 2 power and 2 grounds. Do I need to wire both of these? Can I use a distribution block from my current wiring to split into 2 in and then another block for 2 out to 1 ground? Thanks
hondakid1996 Posted February 12, 2014 Report Posted February 12, 2014 You need 2 runs to support the current that amp will pull. Arc uses GH circuitry to gain clarity but sacrifice a little efficiency (as far as I know anyway, could be wrong) but either way, that amp will pull up to 500 amps which 1 piece of 0 gauge cannot support.
Karkov Posted February 12, 2014 Report Posted February 12, 2014 I agree, you need to run both. 2007 Chevy Tahoe (SOLD) 12 ~ FI Audio X series 10" w/BP option 2 ~ DC Audio 5.0K @0.67 3 ~ DC Audio 5.0K @1.0 2 ~ PPI 3 way sets (not installed yet) 1 ~ RF T400-4, 1 ~ RF T600-2, 1 ~ RF T600-4 4 ~ CT Sounds 5.25" Strato comps (rear fill only) 1 ~ XS Power D4800 1 ~ XS Power D3400 8 ~ XS Power XP3000 160 stock alt, Mechman 370 Elite, 185 DC Power 320+ Sq. Ft. Sound Deadener Pioneer AVH-X5500BHS Youtube: https://www.youtube.com/user/knfjdkghjudfhsgkjdhf/videos?sort=dd&view=0&shelf_id=0
Recommended Posts
Archived
This topic is now archived and is closed to further replies.