Jgrizz Posted February 13, 2014 Report Share Posted February 13, 2014 Hey guys, been messing around with some designs for a single X-12. Could someone double check my design for me and make sure my design isn't flawed? Or any opinions. Thank you. Sorry if pictures load huge. Visuals Link to comment Share on other sites More sharing options...
CleanSierra Posted February 13, 2014 Report Share Posted February 13, 2014 I think you need more port area for that sub. I'd shoot closer to 35-45" if it were me. Everything else looks ok, maybe a tad more airspace even sounds 2.5 cubes. The airspace suggestion is only if you're going to run near RMS, maybe up to 1500W or so. Im not the one you want to try to troll. Just a fyi for you. Link to comment Share on other sites More sharing options...
Jgrizz Posted February 13, 2014 Author Report Share Posted February 13, 2014 Thank you for the input. My only problem is space in my vehicle. I was going to push closer to 2000 watts, do you think this will work a little better? Link to comment Share on other sites More sharing options...
CleanSierra Posted February 13, 2014 Report Share Posted February 13, 2014 I still think you're lacking port area. I would bump the port area up to the range I suggested, closer to 45" if it were me. Im not the one you want to try to troll. Just a fyi for you. Link to comment Share on other sites More sharing options...
john253a Posted February 14, 2014 Report Share Posted February 14, 2014 idd deff 40-45 sq" of port i need if you aiming for 2 net you really want more but its just not achievable any resin why you want a 30hz tune with so little net you'll lose the the upper freq too early idd up the port and leave the length where it is and see what you get then adjust where needed Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.