jmanjr82 Posted March 21, 2014 Report Posted March 21, 2014 Perhaps this amp would be best suited in a burp vehicle wired low?
corrie32 Posted March 21, 2014 Report Posted March 21, 2014 This is what the manual says about dynamic test. i just don't know how you can dispute this test USING DYNAMIC POWER MODE A Dynamic Power Run will send a burst sine wave signal through the amplifier to measure the amplifier's ability to produce the dynamic peaks contained in music. The AD-1 will read the highest clean power that was produced during a burst. The B+ voltage that is displayed on the screen corresponds to the B+ voltage at the amplifier at the exact moment that the last highest power reading was taken. 0. Select START DYNO and unpause the track. (The track contains 5 seconds of silence followed by 10 seconds of burst tones, followed by 5 minutes of silence so the operator has time to record the measurement and stop the track). 11. The AD-1 will display the true maximum RMS dynamic power per channel that was produced before clipping of the signal occurs, and the corresponding B+ voltage for the measurement. i love this sh--t man 1966 Ford Fairlane Pioneer prs 80, the big three, with 2 big azz agm batts, dual 270/200 amp alts , two 8'' mids and tweets in the kick( PPI phantom 600.2). two 10''s and tweets in the doors, two 10'' mids and tweets in the rear decK ( Lanar opti 500x2). 2 C2 Audio Threatcon 4 12s on a Crunch GP3000d. No crossover .
Recommended Posts
Archived
This topic is now archived and is closed to further replies.