couchlockd Posted October 18, 2014 Author Report Share Posted October 18, 2014 aight imma push it back as far as i can get it Link to comment Share on other sites More sharing options...
bcbrassard Posted October 18, 2014 Report Share Posted October 18, 2014 Clean set up. Good job. Link to comment Share on other sites More sharing options...
Tecomah Posted October 18, 2014 Report Share Posted October 18, 2014 Looks good. But yeah push it back 750??! Yeah, fuck that. Fuck this website, fuck SMD, fuck Steve, fuck all of his butt buddy mods, and their couches.^ DON'T BE A DICK LIKE THIS GUY Team Subsonic Lows Link to comment Share on other sites More sharing options...
couchlockd Posted October 22, 2014 Author Report Share Posted October 22, 2014 well this is what happend, sounds like shit and has what seems like slow response when i pushed her back. then i pushed it back to the cab and got some left over pipe insulation frome water heater installs, and sealed it up all around the edges and top. there is a gaping hole in the rear deck were the factory amp was. but either way, when i sealed it up as best i could, i did notice a definate increase in felt bass. i judge this by how far pennies jump in the ash tray when i play a 40hz 0db test tone. i know the seal job is at maybe at best 90% sealed off, imma get some MDF and just frame the trunk opening to the back seat , and then seal the box in it. now this is the thing, i do have 3 of these 12's 2 d4 ohm and one single 4ohm. when wired like so, woofer 1 = coils series 8 ohm load, woofer 2 = coils in parallel 2 ohm load and wire them all together series which would give a 1.14 ohm load at nominal impeadance. i really want all three in there. maybe sealed box cab fired , not sure just yet Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.