deadbroke Posted June 10, 2015 Report Posted June 10, 2015 Got a new sp4 and was looking to use bolt and t nut went and bought 1/4 screws came home to mount and they are too big. Should I drill it out does anyone do this? Is it a bad idea?
Kyblack76 Posted June 10, 2015 Report Posted June 10, 2015 Im going to add more mount holes to my teams when i get em.... just watch out, you may roll the entire surround up when you drill. You ever drill something, and get your glove caught in the bit? The surround is so stout ive seen more than a few people wind their surround up............. other than that, just drill some holes..... Im going to.. SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold
Kyblack76 Posted June 10, 2015 Report Posted June 10, 2015 your looking to just make the holes you have larger, go in from the rear (yup), and use a step bit.....multi bit, spade bit, ... whatever you wanna call it.... again, just pay some attention, and dont roll/wind up your surround around the bit you chose......... SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold
Katt Posted June 10, 2015 Report Posted June 10, 2015 Unibit, Kyle? But yeah. Also, if you're adding more holes around, do a pilot hole, with say 1/8". And go slow, so you don't crack the basket to be safe. *06 330i - Sundern x12 - saz-3500* *91 Foxbody V1 S-Trim Notch*
Recommended Posts
Archived
This topic is now archived and is closed to further replies.