MotorCityFats13 Posted December 29, 2015 Report Share Posted December 29, 2015 there are many ways to complete the wiring as long as the DMM backs up what you did...when I look at your diagram it makes me think the curcuit is not getting completed... .but point bieng this will probably smoke your amp because you will be well under .8 when you are done Link to comment Share on other sites More sharing options...
reedal Posted December 29, 2015 Report Share Posted December 29, 2015 Yes. You can do that. It's the same thing. His just has the connection going out a little further than yours shows SMD Tool Map https://www.stevemeadedesigns.com/board/topic/193176-smd-tool-map-new-november-2014/ Build log https://www.stevemeadedesigns.com/board/topic/197217-reeds-03-tahoe-hat-sqaq-singer-xs-shca-cockbox-80prs/?page=32 Link to comment Share on other sites More sharing options...
NightmareImpala Posted December 29, 2015 Author Report Share Posted December 29, 2015 Ok cool. I will have to play with the subs when they arrive and find the best coil configuration. If nees be i can wire each bank to 1.6 ohm the bring the final load up TEAM DISTANT THUNDER Link to comment Share on other sites More sharing options...
MotorCityFats13 Posted December 29, 2015 Report Share Posted December 29, 2015 if you wire each bank to 1.6 then the last connection will be parallel instead of series ending in a final of .8 ohm.... there may be many ways of wiring them but the end outcome will be the same Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.