Jump to content

Kenwood bass control and rcas ass backwards?


Recommended Posts

Ok. So ive got 3 rcas on back of the Kenwood touchscreen..

Sub

Front

Rear

I've triple checkd each amps rcas are connected properly. 

The sub rcas go to the sub amp

The front rcas go to 2 channels of my 4 channel amp

The rear rcas go to the other 2 channels on the 4 channel amp (bridged connection to run a 10" sub)

 

NOW. I have a sub/bass lvl on my equalizer settings menu. The sub/bass level goes from -50 to +10

When I turn it down to let's say -10 the bass doesn't go down. The front speakers do leaving me only with bass. I've triple checked this shit for days. And nothing's hooked up wrong. And I'm just scratching my head now.any ideas?

Daily driver

  • Crescendo Audio Encore 4.5k
  • Fi SP4v2 18" ( 5.5 cube vented tuned 27hz)
  • Hertz Millie mid-range, tweets, xovers
  • Hertz SPL Show 10" mid-bass ( 1 cube sealed box)
  • Hertz hdcp 4 channel amp
  • 370 amp mechman hairpin
  • 2x d3400 XS Power batteries
  • 2/0 gauge 100% ofc welding/ground cable (big 3 done)
  • 40 ft.2 second skin pro/ 40 ft.2 dynamat extreme ( doors sealed)

 

 

Link to comment
Share on other sites

Bump

Daily driver

  • Crescendo Audio Encore 4.5k
  • Fi SP4v2 18" ( 5.5 cube vented tuned 27hz)
  • Hertz Millie mid-range, tweets, xovers
  • Hertz SPL Show 10" mid-bass ( 1 cube sealed box)
  • Hertz hdcp 4 channel amp
  • 370 amp mechman hairpin
  • 2x d3400 XS Power batteries
  • 2/0 gauge 100% ofc welding/ground cable (big 3 done)
  • 40 ft.2 second skin pro/ 40 ft.2 dynamat extreme ( doors sealed)

 

 

Link to comment
Share on other sites

Got it sorted. Reset my Headunit to factory settings. 

Just adusted my time alignment. Shit sounds way better. 

There's a speaker select menu on my HEADUNIT where I can click on my speaker location. Name the size of speaker and set a slope/octave and and a low or high pass filter or click bypass.

 

since my components have a nice passive crossover and my amp settings are all set with the dd1. Should I just select bypass on my HEADUNIT so I'm not filtering the signal twice. 

Daily driver

  • Crescendo Audio Encore 4.5k
  • Fi SP4v2 18" ( 5.5 cube vented tuned 27hz)
  • Hertz Millie mid-range, tweets, xovers
  • Hertz SPL Show 10" mid-bass ( 1 cube sealed box)
  • Hertz hdcp 4 channel amp
  • 370 amp mechman hairpin
  • 2x d3400 XS Power batteries
  • 2/0 gauge 100% ofc welding/ground cable (big 3 done)
  • 40 ft.2 second skin pro/ 40 ft.2 dynamat extreme ( doors sealed)

 

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 237 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...