Wiring Help

[01tahoeman]

How do you plan on using them? are they mids and tweets?

10 rms 20 peak @ 4 mid or tweet?

50 rms 80 peak @ 4 " "

20 rms 40 peak @ 4 " "

20 rms 40 peak @ 4 " "

I am assuming they are just raw drivers with no crossovers? which means you would have to have a seperate amp for each set , or an active crossover with 4 sets of outputs one for each set of speakers and use a 2 four channel amps. Because tweets and mids should be crossed over at different frequencies. (not saying your stupid but you said your a noob so I wasnt going to assume you know all that.)

10-20 is 80-20khz full range

50-80 is 5khz-20khz tweeter

20-40 is 40-20khz full range

20-40 is 5khz-20khz tweeter

[roscoe1129]

Umm since you are new to this I would suggest just getting 2 componant sets that are the same and using them instead because I am pretty certain your not ready for x over building and bi amping. That way you can get a four channel amp that will push the same wattage to each set and call it a day. A lot less wireing and mess.

[01tahoeman]

http://www.tb-speaker.com/detail/1230_04/w2-803sm.htm

http://www.tb-speaker.com/detail/1208_03/w4-1052sd.htm

http://www.tb-speaker.com/detail/1208_03/25-1414sc.htm

[01tahoeman]

could i say screw the tweeter and put 2 full range, two 10/20 's and one 20/40