Need Help Wiring Subs.help!

[zacht214]

i fell real dumb asking this question but im so confused right now i got a 2 channel amp and 2 dvc subs. my question is how would i wire them to get a 2ohm load ive seen diagrams on crutchfield but it only shows a 4 ohm load and on the12volt and it says i can only get a .5,2,or 8 ohm load also on the 12volt the diagram looks like it showing for a mono amp any one know a good diagram or can explain to me how i would get them to 2 ohms on a 2 channel amp

[littleitaly1990]

what ohms are the voice coils,....like dual 2 ohm, dual 4 ohm...etc?

[97maxima]

a dual 2 woofer can be wired to 1 ohm or 4,if that amp does 4 ohms mono at full power do that.pos on coil one to neg coil two,thenrun the empty terminals on to the amp pos and neg as normal,what amp is it

[zacht214]

they are dual 2 ohm its a Crunch P1400.2

Edited October 3, 2008 by zacht214

[zacht214]

bump 4 some help

[Audiobahnaholic]

Wire one to each channel like that. According to Crunch that will give you 350 watts per sub.

[Torres]

what kind of subs are they? you can bridge the amp to get a 2 ohm load, but i dno if amp can handle it.

[zacht214]

they are re se 2ohm and they are dvc subs the amp says its bridgeable how would i bridge it

[zacht214]

what kind of subs are they? you can bridge the amp to get a 2 ohm load, but i dno if amp can handle it.

so does any one no how i would go about bridging it

[Loudcav]

I doubt that that amp is stable at 2 ohms bridged not many amps out there are