Mosin Posted October 30, 2008 Report Share Posted October 30, 2008 aight...the amp wouldnt get too hot because i kutt a lil bit of wire to fit the wire into the amp?... Naw, your good... What size ground you using? Quote Derp. Link to comment Share on other sites More sharing options...
DUBIE Posted October 30, 2008 Author Report Share Posted October 30, 2008 i was thinking the same 1/0 gauge...but make it as short as i can.. Quote Link to comment Share on other sites More sharing options...
Mosin Posted October 30, 2008 Report Share Posted October 30, 2008 Sounds good. You seem to be set. Stay away from the 4G though, like everyone else stated... Quote Derp. Link to comment Share on other sites More sharing options...
DUBIE Posted October 30, 2008 Author Report Share Posted October 30, 2008 Sounds good. You seem to be set.Stay away from the 4G though, like everyone else stated... aight thanks man!..preciated..!..i just asking because i member in here said i would need a 4gauge wire for my amp...i guess ill keep that in mind BIGGER always BETTER!.. Quote Link to comment Share on other sites More sharing options...
Bass4Lyfe Posted October 30, 2008 Report Share Posted October 30, 2008 aight thanks man!..preciated..!..i just asking because i member in here said i would need a 4gauge wire for my amp...i guess ill keep that in mind BIGGER always BETTER!.. that quote is good for wire sizes ... just make sure to match your ground and power and that quote does NOT HOLD for FUSES use a proper fuse and you'll be good to go Quote ~Matthew 1998 Toyota Camry XLE V6 3L (1) ScyTek Astra 4000RS-2W-1 2-Way Remote Start Alarm with Shock and Proximity (1) 20% Tint All Around (Gately Audio) (1) 250 Amperage HO Alternator (1) Big 3 Done In 1/0 (2) Kinetik HC2400 Power Cell (1) Alpine IVA-D106 Receiver (1) Peripheral Video Bypass Device (4) Alpine SPS-17C2 Speakers (1) Alpine KCE-422i iPod Control Interface (4) Sheets Dynamat Extreme; for speakers (1) 10 Square Feet Hushmat (Trunk & Rear Deck) (4) DC Audio Level 4 15" D2 Subwoofer w/ Level 5 Coils (1) Wall Built By David, Tuned to 32 Hz (1) Rockford Fosgate T40001bd Amplifier (1) Stinger 1/0 Wiring (2 runs of + 2 runs of -) (1) Stinger Volt Meter Link to comment Share on other sites More sharing options...
infkt Posted October 31, 2008 Report Share Posted October 31, 2008 just fold down the strands that don't fit and electrical tape them to the insulation shit so if you get an amp that can fit 1/0 guage you can untape and fold back up. Quote Link to comment Share on other sites More sharing options...
tacomabanga1986 Posted October 31, 2008 Report Share Posted October 31, 2008 were was u at when i was doin my install^^ i waisted almost a foot of 0guage tryin to trim it so it would go into my amp and it takes 0guage but the screw wouldn't bite it, and why not just try a dist block? run 0guage in and 4 out? thats what i do, and it will look alot better and u can run more than 1 amp off of it if need be, hope this helps Quote here's a link to my system 99 toyota tacoma , 2 mtx 8000 1504's in a sealed downfire , 1000w memphis amp here's a link to my other system my 90 geo prizm test car heres a thread i got of new songs u can dl that are legal = Some Good Bangage/you Can Dl These Free And Legit Link to comment Share on other sites More sharing options...
psturmer Posted October 31, 2008 Report Share Posted October 31, 2008 more wire = less resistance = less voltage drop = healthier on the amp. Quote Ford Explorer 2000 4 12'' Type R's under window line Legal: 155+ dB Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.