Steps To Fiberglassing

[Crump]

For the inside of a box, is it 1. Resin, Let it Harden 2. Resin again with fiberglass cloth is that it or what else do i need to do?

[zfrerichs]

add at least three layers of cloth i would say mat if anything but i put a coat of just resin first then layers of resin and mat after

[The Performer]

Look up other threads and get some more information first of all and everything you'll need to know is out there.

Otherwise, man I wouldn't really worry about that many layers of glass if any on the inside.

[zfrerichs]

performer is right it depends on what your running basic set up dont need and glass really but its what you prefer really

[Helidude]

I'd say if your cuts aren't really clean and tight.....this is a good idea. If your cuts are pretty good.......I would say don't bother unless your pushing alot.

I would assume that you should/could put matt in the first layer of resin, as their is no stregth in resin alone. Not sure if there is any reason to put a coat of just resin on first.

[The Performer]

I'd say if your cuts aren't really clean and tight.....this is a good idea. If your cuts are pretty good.......I would say don't bother unless your pushing alot.

I would assume that you should/could put matt in the first layer of resin, as their is no stregth in resin alone. Not sure if there is any reason to put a coat of just resin on first.

Even if they aren't very clean cuts, just a good seam of wood glue or latex caulk would be fine.

[Crump]

well i am going to push around 1700 watts to two Fi SSD's? so what should i need to do, Resin then cloth then more resin, or just resin

[C 45.]

if you so want to do resin and cloth in the first layer make sure there are no air bubbles or stuff like that then add only resin after all matt or cloth is done to make sure it is smoother thats all and btw never use latex caulk that shit shit flexes you shouldnt need it if your cuts are good enough if there not you have no buisness building a box really

[Helidude]

Even if they aren't very clean cuts, just a good seam of wood glue or latex caulk would be fine.

Yup...I agree

[The Performer]

if you so want to do resin and cloth in the first layer make sure there are no air bubbles or stuff like that then add only resin after all matt or cloth is done to make sure it is smoother thats all and btw never use latex caulk that shit shit flexes you shouldnt need it if your cuts are good enough if there not you have no buisness building a box really

Well said.