t-roy Posted May 14, 2009 Report Posted May 14, 2009 around what fq do you run your mids and highs at? and do you run them on full or high pass on the amp, i have a power bass asa 400.4 and some phoenixgold 6x9's and a set of there comps, just looking for refrences from others. thank you
wL<3bass Posted May 14, 2009 Report Posted May 14, 2009 ~60-65hz highpass @ 100wrms per side on some RSD6.5" comps. Vehicle: 1997 S10 Blazer 4dr 4X4 Exterior: Rear End Bagged, Black Grill, Lifted 2" Amplifiers: Rockford Fosgate T8004 & T10001bd Batteries: 2 Stinger SPV35, Kinetik HC2400 Electrical: Big 3, DC Power 290amp Alternator w/ MLA at 15.5v Enclosure: 4.2 ft³ @ 33Hz 84sq.in. of port (20sq.in. per cube) Headunit: Eclipse CD3200 w/ 80G iPod Mids/Highs: Rockford T152s (a-pillars), Rockford T162s (doors) Subwoofers: 1 15" Fi BL Fully Loaded Wire: All 1/0g Kicker Hyperflex My YouTube Videos My Fiberglass A-Pillar Build My "Seamless" Looking Box Build My DD1508 T-Line Bandpass Build "Seamless" w/ Acrylic Windows (for '05 TrailBlazer) My Stealth 8" Fiberglass Build (for '05 TrailBlazer) My Build For A Friend's '08 Cobalt 15" BL Sealed Off From The Trunk My feedback/references...
Boon Posted May 14, 2009 Report Posted May 14, 2009 120hz 12dB highpass on the midbass, 250wrms each side into Fusion FJL-65's then 3.5khz highpass @ 18db on the tweeter. God I love my RF360.2... 10.x volts fo' life!
raytard Posted May 14, 2009 Report Posted May 14, 2009 ~70hz 12db, 150rms to each crossover (2 in each door) the one on my deck is set at like 63...with as much power as i have i get bottoming out problems and funky distortion if its set any lower Build: http://www.stevemeadedesigns.com/board/ind...hl=avalon+build monster/rockford/kicker/stinger cables, pioneer source, jbl highs/amps, kinetik/shuriken batts, iraggi alt, dei security, dc subs(atleast for now) Team DC
Recommended Posts
Archived
This topic is now archived and is closed to further replies.