stevh0 Posted May 8, 2007 Report Share Posted May 8, 2007 Guys i have a major problem Build 4.6 cuft box for 2 15's subs up port to the rear , i wanted to tune it low (30hz) so my port is a 3.2x 4" but its no where as loud as i expected it to be . i could just be used to the 4 x 15s or just plain deaf . i thought about dropping in a slot port and if i do that and go with 3 inches wide and 12inch deep , but that bring the tuning to 37hz . would i have any port noise with the 2 15's ? if i go wider to say 4 inch it take it to 41hz ? for daily bumping is 41 hz too high ? Link to comment Share on other sites More sharing options...
stevh0 Posted May 8, 2007 Author Report Share Posted May 8, 2007 nevermind Link to comment Share on other sites More sharing options...
Slinky Posted May 8, 2007 Report Share Posted May 8, 2007 you figure it out? DD M4 Rockford Fosgate P500-4 SoundQubed HDC415 w carbon fiber cap 2 Rockford Fosagate T1675-S XS Power D3400 Under Hood XS Power D5100 in rear Michael Singer 200A Alt Build Log: http://www.stevemeadedesigns.com/board/topic/153901-2012-veloster-update-842013-wall-build-4-15s/ Link to comment Share on other sites More sharing options...
stevh0 Posted May 8, 2007 Author Report Share Posted May 8, 2007 kinda . went with a 2.5 wide / 13high 12 deep tuned to around 38hz . hope theres not too much port noise Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.