Subsonic Filter

[ant the ninja]

What should I set it at? This is the first amp I've had with an adjustable one so Im not even sure what to do with it. (ap15001d) I have it at off right now.

Also the amp has 4 speaker connections but its a mono amp, I have two 4 ohm svc subs at 2ohms, Is it possible to bridge it to one channel on this amp for a final load of 1ohm or am I missing something here...

Edited September 23, 2010 by ant the ninja

[dugee81]

~5hz below your tuning (ex. box tuned to 38, turn SSF to 33)

[ant the ninja]

How do I figure out the tuning for a sealed box? I didnt build this one is was giving to me by brother a while back whos friend built it for him.

Edit: wait, you cant tune a sealed box? Unless Im confused

Edited September 23, 2010 by ant the ninja

[dugee81]

you cannot tune a sealed box. hm im not sure what to do for that then. maybe just set it to 30hz ? ?

edit: or maybe you just keep it off. hopefully someone more knowledgeable on the subject can give their opinion.

Edited September 23, 2010 by dugee81

[Beanz]

From what ive read your able to just turn it off in a sealed box since its not tuned its just sealed.oh and the wiring dont try and bridge it keep it at 2 ohms...

[ant the ninja]

From what ive read your able to just turn it off in a sealed box since its not tuned its just sealed.oh and the wiring dont try and bridge it keep it at 2 ohms...

Yeah I have it set to off right now, I wasnt sure if I should have it somewhere or not and would that be considered bridging even though its a mono amp? Thanks again to everyone for the quick help.

[fox_racin4]

From what ive read your able to just turn it off in a sealed box since its not tuned its just sealed.oh and the wiring dont try and bridge it keep it at 2 ohms...

orly?

its internally strapped to make wiring easier if you hook one sub up to each side it will run the amp at 1 ohm or conect both pos and both neg from subs and run it to one input will be the same

[MrSkippyJ]

Yeah I have it set to off right now, I wasnt sure if I should have it somewhere or not and would that be considered bridging even though its a mono amp? Thanks again to everyone for the quick help.

No it wouldn't be bridging it. the terminals are internally connected. it is simply more connections.

[Robert8252]

You don't need it on at all. A sealed box acts as a cushion that makes it "near impossible" to bottom a sub out in it. Just for shits n giggles you can set at at about 25-30 if you want since not much music goes that low. So 1/4-1/2 way. But I'm not too happy with the subsonic on the AudioPipe right now. I can crank mine all the way and I can still pick up 25hz for some damn reason..........

[ant the ninja]

orly?

its internally strapped to make wiring easier if you hook one sub up to each side it will run the amp at 1 ohm or conect both pos and both neg from subs and run it to one input will be the same

So even though I have my subs running at 2ohms, even just hooking the subs up to 2 of the 4 pos/neg its still dropping it to 1ohm or is it keeping it at 2ohms? Sorry if I am asking too many questions.