7jezuz7

Can you make an avatar of a sub moving from a video clip? Edit: Didn't want to post again, my sub. I have a video where I like how it moves but its about 80Mb. I can upload somewhere if you want. I'll post a link in a bit. Just find a couple of seconds where you think the excursion would look good. And thanks!

These are old body style though, unless they're willing to do some body work.

How about these link: http://www.mytightride.com/caes20eustta.html

So, I hit a dead end and I don't think I'm allowed to cut anything up. I could have just gone to some junkyard and hopefully found two of those turn signal connectors from an Impala and wired it in parallel But that red and white are sealed off from each other and can only be used as a reflector unless I cut it up Not completely sealed off but you get the point

Okay, yea I get you. I'll try it tomorrow and if I succeed I shall post up steps and a video with an end result. I'm pretty sure others would like this as well. Thanks! Still open to suggestions though.

I just saw this right now, but I'll go try it out first thing tomorrow and take the back apart to experiment with. So I just add a turn signal bulb and then splice wires and jump them to where I want the turn signals to be? Would that be turn signal wire to +ve on the non-signal bulb?

there ya go

I saw this on Cardomain under Impala and loved it and if anyone can enlighten me it would be appreciated it starts around 23 seconds. I want to do that with my rear turn signals so that when I choose to turn right or left both circles will light up. I tried Google search but didn't get far Here's the vid! & thanks in advance for any help

haha they just don't stop insisting. I'd of left at them saying 5 x 14 = 25 the first time

I read somewhere that you use 1 pound of poly fill per cubic ft, so 2 pounds for each of your chambers. I would try just one chamber and see if it actually makes a difference rather than go out and get a lot to be disappointed or something, I wouldn't know (haven't tried it) just saying

or you could add poly fill to make em go lower. somebody correct me if im wrong. just experiment with different box sizes and polyfill if you can

There ya go

Thanks Steve, I appreciate that.

XwD0szgjk20 http://www.youtube.com/watch?v=XwD0szgjk20 New vid I made. If someone can tell me how to embed, I will. Got it

another one :]

Is there a certain amount of power where this kicks in? My subs and amp play the higher end notes way better than the lower ones and it doesn't dim my lights or drop my voltage at all on the higher notes like the low notes do. By high I mean around the 38-45hz or so and by low I mean about 27-34hz and the amp is prob. doing about 450rms @1ohm on a stock batt/alt(105)

I saw this on one of yahoo's stories and was reading through the replies and saw that someone posted this up which then made me think I should share it here. Link to the Story A reply to the story: "Remember what Ben Franklin said, early to bed and early to rise, makes a man healthy wealthy and wise." Someone else replied to that: "It should be noted that Mr. Franklin said this in an era when it was impossible for his neighbors to buy or own window-shattering subwoofers."

Is it working though? If not here's another link I just uploaded to: http://www.megaupload.com/?d=NJWTLMBA Enter code, download file, wait 45 sec. then download

I just downloaded it no prob. Try the second link w/out the dell manager

So it's ok to use birch for sub boxes? I can get me some 4x8 for about $10 and if it's good then I plan on getting me a couple of sheets to play around and experiment with for boxes.