RandyAudio

I have a 9800 bt with a xm tuner with prepaid xm for 2 years.

It programs and works till it's the first start in the morning. But after the first one it's fine.

I did that then I stayed on even after it started

It's not a doesn't start it just bumps the starter a few times to start it instead of the starter staying on till it's running.

I'm using the 556uw. Key in it with ring sound lock cylinder. I'll see if I can find the tach wire you speak of. Thanks.

I'll fill the box with water and get a definite size but I'm almost sertin the it's going to be very close to 2.6ft^3 from what I've measured out. The port will be cut out of the cupholder area in the center so 6-10 inches of port can be external.

the box will be built up 3" maybe 4" vertically.

and need my whole bed too. maybe i just want to much.

i'm opening a stereo shop and want to be able to wow the people in this small town but the downer is that i have a new baby and need the seat for a carseat. do you think 2 lv2 8's i could get around a mid to high 130? id love to do 140 but i know i dont have enough cone and space and it still be good for everyday music.

its fiberglasssed into my storage compartment under my rear seat and its 2.6ft^3 max and 3" off the base in the pic. i was thinking center port.

anyone here worked with the lv3 10's? i have 2.5ft^3 total to work with and want ported and loud. help please

You can use 12v from your car but mainly to test polarity. You can use it both ways and one should go in and the other make the cone move out. But some won't have problems till played by an amp. But yes you can test it a sub just needs a little more then a 9 volt battery. Move the cone by hand if it's crunchy sounding or gritty as it moves then it's done for.

?

Put In a viper remot start 2 way a few weeks ago it takes a resistor for the starter and pulled tach off the cam sensor. I have tried to use all the options for tach sens and voltage. But when it's first started in the morning it Trys starting by bumping the starter instead just running the starter till it starts also it has stuck the starter on till I went in and shut it down the remot start by pressing the brake. Anyone seen this and know what it takes to fix?

I handle my own 4 x 8 sheets, just saying I could to but 4 hands is always better then 2. and why not get a little quality time with the wife doing what i like to do. and now she can make cuts on her own.

definatly beats having to have the wife help me weild a 4x8 sheet of mdf on the table saw.

Been looking for a panel saw for a while now. happened to look on craigslist a few days ago and found this OBO. called and he took $100 for it. its a aluminum Dewalt with a new Milwaukee saw on it. Works great.

Toyotas usually have a harness for the alarm between the ignition switch and it's harness just remove t harness and plug it's wiring directly into the ignition like it should be.

MTX 9500's have a high roll.

So slot port would be best.

I think I'm just going to end up doing fiberglass under my rear seat so it will be about 2.5 ft^3 befor port and subs so if you could let me know what a good port size would be that would help alot. The port max dimensions would be 10" wide, 4 " tall and 12" deep.

OOOPS

is the equivalent volume[vas] not what i should be going off of?

didnt do rims yet but here is it slammed. not the best photoshop job.

The kicker manual says .36 per sub.