Ray

Make a wood ring around fuel pump door Fg everything else. Done

You are correct You can bandpass like that.

And getting loud low in a trunk??

A 50 is a great number. Mines not loud sealed up. Its a headrest monster.

Cool beans.

Sealed on the glass?? At what freq?

Haha. Ill try a hoodie tomorrow. Or some paper

And the door is still just cut out. I think i might do a pod for a few 6's soon.

I curious to see what yours meters. That will help me decide what to do next. And that was my console on a "clean" day. Haha

Who the fuvk still wears a leather jacket?? Lmao Plus it wont do much weight with both windows down. I dont care to barely crack a window just to see something move. I like all windows down tricks.

I tried 4 paper towels first but it just blew them out the window. Wouldnt make for a very good vid. Happened to have those XS bags in the truck.

Hers a better highs vid. Case you summabish's missed it http://www.stevemeadedesigns.com/board/topic/135313-my-ranger-doin-the-4-8-shake/page__pid__1904768#entry1904768

Hghs are a 6" and tweet Hertz hsk xl6" And mille ML280 tweets Active on a zed levithian 150 per driver Cut at 4k 24db 6 plays to 60

Did you watch the other vid 727?? Its in the vid section.

Of course the thanks is for joo. Haha I might try 6 soon. Or just go to the single 15

Jl1000/1

No ddc??

Video explains it all i guess.

Feel free to get my number from james. And call me tomorrow. Ill walk ya thru a few things.

Yes... I know. Ugh. To Much Stuff I Want Lol

The amp will go into first stage overload with any clipping at all. Its very smart. But thats only cutting 25%. Honestly id try it by ear and see if its cool. Play a heavy bass song like hypnotize with everything up, then slowly roll in the gain untill it stops getting louder then back it off just a tiny tiny bit. Just a hair down. Then try a few songs full tilt and see if it still does it Like i said it is a very sensitive amp to clipping. Hell when i had 1 my 5.1 was always on 1st stage overload. Lol

Thats just the dd1 ground ref. Just hard to believe a 5.1 is bad straight from audison. Their failure rate is 1:200,000 Could happen but i just wanna go over all the tests first.

Start with the basics. Try no lc1 So straight from deck. Try vol at 30 Meter the rca voltage on a 0db test tone. With no load hooked up see if you can go 3/4 gain on the amp. Without any buzzing.

I saw an audio control piece What is it? What is your exact input voltage to the sub channel? Over 5v?

Try it in the neg spkr terminal on the amp. And move ground to amp ground please.