SMZ2

I think ill go with that one then. Will any bracing be needed if I am doing a double baffle? And if its not asking to much could I get the inside sketchup of the specific one I know how the port it supposed to look but pictures always help haha. Thanks man

I'm liking the third one you posted that was tunned to like 32hz with the slot port on the side

Could you give me a sketch please just to help visualize when you get a chance

Nah it didn't come with a specs sheet... but I could take some measurements

Okay my depth without the amp rack is 2ft x 7 inches to the top of the seat that was with the trunk closed all the way to the trunk. and 3 ft all the way at the bottom of my seats the seats sit at an angle. Hopefully this added space will help design an appropriate enclosure. Thank you.

Aight man I can get a measurement of the max depth tomorrow but I'm pretty sure it'll only give me a few inches like 2 or 3 because the amp rack is pushed up against the seat

Okay just got the sub today! Here are the dimensions in 3 ft x 6 in for the width, 2ft for the depth I made an amp rack that takes up depth space if more space is needed I will remove it and mount the amp to the box once its built and the height is 1ft x 4 inches and that is right below the window line. Thank you for the help.

Wow those look amazing great work guys! I kinda want to make a wall that goes to the top of my back seats and mount them there.

Looking for some amp rack ideas for my 2002 nissan xterra. So post your amp racks in your cars, trucks, and suvs, so I could get some ideas please. Thank you

It will be hooked up to a crescendo bc2000 I will get measurements in the morning. Thanks for the advice man I will definitely try that.

I need help designing a box for a fi/psi 18 the motor is from a old fi bl motor. It will be going in a nissan xterra I want it to be tuned between 30-32hz. Also can I get some help on wiring direct leads in parallel on the inside of the box?

Just bought this cant wait to see this on my front door

nope just a headunit

Bump... anybody got a headunit looking for a touchscreen with 3 preouts 4v I'm looking for a 3200bt or 3200dvd or something similar

Shipped to 27809? I've been looking for some 0 guage power wire

Looking for a 2000 watt amp preferably a bc2000 or aq 2200d or something similar. I am also looking for a touch screen headunit preferably a pioneer and I'm looking at alittle under 300 dollars hopefully. Lemme know whatcha got.

I'm going to find a guide for my saw. I would use the square to draw out all my lines to set the cuts up right and have them planned out. Could someone point me to a good rip guide?

So just using my circular saw would be better? I need to go get a carpenter square then would I only need a carpenter square or do I need to buy or make a guide also to ensure they are straight?

so are rip guides better because I already have a circular saw. But the table saw was like 80 buck and a craftsman it was on craigslist

Okay this may sound dumb but a 10 inch table saw will be big enough to cut out piece for say a box to hold 1 18 or even 2? I just wanted to know before I buy one of craigslist. Thank you.

Dude no way I'm located in rocky mount too ill have to check out auto phonics man I'm looking for somewhere to get an install job to learn more about custom boxes and all and make money of course and all I dropped a resume by wires ill have to check out auto phonics too thanks man

Dc 2k shipped to 27809

Are these sold?

What is the impedance?

Would these keep up with say and 18? I need some new components... for my build.