Jump to content

Replacing a ignition switch


Recommended Posts

Posted

I have a 1995 chevy lumina (the car) and I need to replace the ignition switch, how would I go about doing that and how big of a pain is it lol, I know I need to pull the steering wheel but not for sure what else.

And not for sure if this would be the correct place for this question but oh well.

Rest In Peace mother.

January 22, 1955 - February 14, 2013

http://www.stevemeadedesigns.com/board/user/35351-megrch/

Posted
On 5/8/2011 at 7:38 PM, Kranny said:
On 5/8/2011 at 7:35 PM, 'Maxim' said:

It hurts me inside when I read stuff like this and remember you're 15

LMFAO so true

:blush:

Mitsubishi 3000GT (Old Build)

Headunit: Pioneer 80PRS

Frontstage: (2) McLaren Audio MLT-2 Tweeters & (4) PRV Audio MR Series Neo 6.5" Mids

Substage: 4 15" Hybrid Subs - Tantric Motors & Sundown Softies

Amps: Banda 2.4D Amp (Tweets), American Bass VFL 350.4 (Mids), and (2) Ampere 3800s

Electrical :Singer 260A Alt & JY Power Lithium

 

2005 Chevy Colorado Ext Cab

Headunit: Pioneer 80PRS

Frontstage: 4 PRV 700Ti Tweets & 6 10" Delta Mids on 3000wrms

Substage: 6 Fi BTL 18s in a 4th Order Walkthrough on 3 Wolfram 4500s

Electrical: Singer "390" and JY Power

My Official Feedback Thread

Posted

i got 4 words. pain in the ass. you should be able to get away without pulling the steering wheel, but to be safe i would make this a weekend project. on like friday night i would pull the negative battery cable off adn start the project saturday morning. this assures that there isnt any residule power left anywhere in the car. the last thing you want is to have to go to the hospital for a broken arm or some other shit. other than that the second e how link seems detailed enough. if you have any questions you can pm me and i can help walk you through it. ive done this many, many times before. i can do one from start to finish in about an hour to an hour and a half depending on the car.

This page is crispy_chick3n approved.

© crispy_chick3n inc

Posted

well every car is different, but as far as i acn tell right now it looks like just snap ring pliers. what size engine is in the car. ill look up exactly what special tools are needed and post exact steps off of alldata tomorrow so you also have every step recomended by the factory.

This page is crispy_chick3n approved.

© crispy_chick3n inc

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...