xl 15 terminal question

[loud]

i am wondering if i wire my subs in parallel at the sub will the two 8 gauge wires be able to fit in the terminals??

[matt402]

yes. u usually have to trim 8awg a lil bit tho.

i put wires in the back & front of the terminals.

[BeatBox]

you can so run the wires from each coil to bolts on the side of the box and wired them down to what ever ohm load from the outside(if that makes sense)

[ChevyBoy95]

well what i do now, i put 1 wire from each terminal to the side of the box (usually bolts) and wire it externally into parallel or series, so if you want to change it, you dont have to pull the sub out.

same thing as said above^^^

Edited July 24, 2011 by ChevyBoy95

[loud]

well what i do now, i put 1 wire from each terminal to the side of the box (usually bolts) and wire it externally into parallel or series, so if you want to change it, you dont have to pull the sub out.

same thing as said above^^^

i do know you can wire out side of box. but this will be only run in parallel(i can only fit on sub in location...no wall yet) and if i was going to add another i would make new bot and then could change where i wire them.

[Robert8252]

I made two 8g wires fit but just use 10g or 12g wire. You won't gain anything with the bigger wire.

[AA98hoe]

2 8s wont fit 1 barely does if you trim it down. put them to bolts like stated above or solder them together to a single run to your amps outputs

[loud]

is this ok to do.

[AA98hoe]

yep