OrionStang Posted November 27, 2011 Report Share Posted November 27, 2011 Sub up port back. Port along the bottom 20" wide and 5" high. Box should be approx 20Hx31Wx30D SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
13mwolson Posted November 27, 2011 Author Report Share Posted November 27, 2011 And what if I were to go with the xl. Since I will be giving it the right amount of power. Will I still need to make the port 18-20 in per cube? Or is it different since I have rated power going to It Link to comment Share on other sites More sharing options...
13mwolson Posted November 27, 2011 Author Report Share Posted November 27, 2011 Sub up port back. Port along the bottom 20" wide and 5" high. Box should be approx 20Hx31Wx30D Thanks for the specs! How will I figure out how deep in the port goes though Link to comment Share on other sites More sharing options...
OrionStang Posted November 27, 2011 Report Share Posted November 27, 2011 35 inches. SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
13mwolson Posted November 27, 2011 Author Report Share Posted November 27, 2011 Nice. Thanks alot Link to comment Share on other sites More sharing options...
OrionStang Posted November 27, 2011 Report Share Posted November 27, 2011 Take an inch off the width, 30 wide. SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
13mwolson Posted November 27, 2011 Author Report Share Posted November 27, 2011 Take an inch off the width, 30 wide. How can the port be 35" deep if I The box only goes 30" deep. Does that mean it folds up 90 degrees once it hits 5 inches to the end, for the port width. Link to comment Share on other sites More sharing options...
OrionStang Posted November 27, 2011 Report Share Posted November 27, 2011 yeah its got to bend. SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
13mwolson Posted November 27, 2011 Author Report Share Posted November 27, 2011 yeah its got to bend. Allright. Do those measurements include the port or is it just the internal net volume w/o the port. Link to comment Share on other sites More sharing options...
OrionStang Posted November 27, 2011 Report Share Posted November 27, 2011 That is the net volume with port and sub displacement accounted for. Gives you 5.4cu ft at 33 hz SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.