Setting up BC3500's for BTL's

[Amart88]

I got my 2 Crescendo BC 3500's in the mail this week. I will be running them strapped to 2 Fi btl 15's (dual 2). Four cubes each tuned to 33 hz. In case i am missing something or forgetting something crucial, What is the proper way to set these amps up so I don't harm the woofers. I don't want to under power them but I dont want to make a stupid mistake and burn them up either. I don't use any bass boost or shit like that on my HU. Got a DD-1 and good electrical.

Thanks

[SnowDrifter]

Why strap? Just run separate.

dd-1 with a -5db tone

SSF to 29 or 30hz

Low pass to 60hz

Turn them down if you smell them.

Not much else to it

[Amart88]

Thanks. I was told to strap them on here a while back. If i strap them I dont have to gain match. and it should still function the same? each one wired paralell to each woofer dual 2 would be one ohm to each amp equal final 2 ohm load when strapped am I correct? also I want to use my Remote knob and i would only need to have one when strapped, no hassle?.