Help me Sketch This Design (2 Havoc 12's)

[RickyFriery97]

The port does have to bend, like n8 said you need the Width of the port away from the back wall.

If my calculations are right, first wall should be 21"

Then 90 degree turn, second peice is 3.5"

Gives you 24.5" physical port length, and 30" of actual port length

Have to acct for the width in the turn to the actual port length

Hope this helps/makes since

[OrionStang]

The port does have to bend, like n8 said you need the Width of the port away from the back wall.

If my calculations are right, first wall should be 21"

Then 90 degree turn, second peice is 3.5"

Gives you 24.5" physical port length, and 30" of actual port length

Have to acct for the width in the turn to the actual port length

Hope this helps/makes since

Doesn't work, because a center port should be cut in half after the bend.

[RickyFriery97]

The port does have to bend, like n8 said you need the Width of the port away from the back wall.

If my calculations are right, first wall should be 21"

Then 90 degree turn, second peice is 3.5"

Gives you 24.5" physical port length, and 30" of actual port length

Have to acct for the width in the turn to the actual port length

Hope this helps/makes since

Doesn't work, because a center port should be cut in half after the bend.

My mistake, I thought you meant a side port with three common walls

[OrionStang]

If I add a 1 5/8th piece after the turn, it only adds an inch to the overall length. Guess i'll try that.