Box for 2 HDC3 15's on 2 AQ2200's strapped

[412 CVX]

the displacement should be closer to .45 you've got to add the displacement for both subs.

[Cutdeluxes1]

the displacement should be closer to .45 you've got to add the displacement for both subs.

oh yeah, good catch. It doesnt chanceto much, but i did change the port with to 18 so i can have 144in² of port area.

[412 CVX]

shrink the net volume. you're gonna want about 7-8 cubes net

[AMI CUSTOMS]

shrink the net volume. you're gonna want about 7-8 cubes net

Wrong

[Cutdeluxes1]

shrink the net volume. you're gonna want about 7-8 cubes net

Wrong

So does it look good or not?

[AMI CUSTOMS]

Tuning is a little low, port area is low, net cubes looks good. 9 cubes net 17-18 sq inch of port per cube tune to 38 hz.

[Cutdeluxes1]

Forgot to check the sub up box....lol

Edited August 7, 2012 by Cutdeluxes1

[AMI CUSTOMS]

I would do the port the full length of the box so you only have one port wall to do, so it would be something like 45 x 3.5 by 18 long. I did 45 width cuz I am assuming you are doing double 3/4 inch mdf all the way around making it 1.5 inch.

[Cutdeluxes1]

Actually this is it....I hope

[Cutdeluxes1]

I would do the port the full length of the box so you only have one port wall to do, so it would be something like 45 x 3.5 by 18 long. I did 45 width cuz I am assuming you are doing double 3/4 inch mdf all the way around making it 1.5 inch.

I was planning on doing double, but couldnt get the numbers I wanted with the limits in outer dimensions. all of these scales are with .75 instead of 1.5 for wood thickness. the box will be attached to a false floor, and is also double baffled so that gives me top and bottom. then I was going to add a piece to the port face and rear, and brace from left to right.