Jump to content

Loud & Low 8th Gen Civic - Time to say good bye to her.


Recommended Posts

Posted

Hmmmm what do we have here! Thank you Mr. Summers!

ScottCarver.jpg

ScottCarver2.jpg

:peepwall:

Looks like it's gonna be a sweet enclosure, tell them to quit playing around that you have serious building you need to get back to!

My Build Thread 2005 F150 : 2005 F150 Center Console Build

Center Console - 3.2 cubes @ 35hz

4 RE Audio SRX10s - Pure Audio 3000.1

8 6.5 Soundstream SME.658 - Soundstream TN4.900D

4 NX-5 Super Tweeters

Posted

So I've been thinking about something guys and I could use some input.

Right now I'm going without a processor on the system. Not sure if there's a real need for it or not. I think it would make for easier tuning to have it all in one spot as far as a processor goes, but I don't know. The plan as of now is to tune the system with the amplifiers crossovers. The head unit, at this point, is just basically for bluetooth, HD radio, and the pre outs. Not really going to be using it for much other than that.

Now with that being said, I'm thinking about the Rockford Fosgate 360.3 (if I can get my hands on one), or the Audison Bit Ten or Bit Ten d.

The pros and cons of these units: I'd love to have the RF cause it's the new hot thing on the market, but I'm not sure I can honestly figure out how to use it. YES I have Mr. Meade around the corner from me, but he's always busy and doesn't seem to have time to do a demo let alone teach me how to use the processor. I love the looks of it, for display purposes, but I'm not so thrilled about the knob controller. I think RF really didn't do themselves any favors by doing this instead of a digital remote control display, like the Audison Bit Controller.

I haven't had a chance to play with the Bit Ten or Ten D at all. But I had the Bit One and man was that complicated. So I think user interface for me is going to be difficult to learn.

I'm sure there are other units out there that will work for me. Matter of fact I'm going to do some research on them and see what I come up with.

But I could use some thoughts and suggestions here guys! What do you guys think?!

Is it worth the money?

Is it going to make that big a difference in my set up?

Does it essentially eliminate my head unit then since most of them all run off bluetooth now?

Thanks, I'll be back later.

Posted

So I've been thinking about something guys and I could use some input.

Right now I'm going without a processor on the system. Not sure if there's a real need for it or not. I think it would make for easier tuning to have it all in one spot as far as a processor goes, but I don't know. The plan as of now is to tune the system with the amplifiers crossovers. The head unit, at this point, is just basically for bluetooth, HD radio, and the pre outs. Not really going to be using it for much other than that.

Now with that being said, I'm thinking about the Rockford Fosgate 360.3 (if I can get my hands on one), or the Audison Bit Ten or Bit Ten d.

The pros and cons of these units: I'd love to have the RF cause it's the new hot thing on the market, but I'm not sure I can honestly figure out how to use it. YES I have Mr. Meade around the corner from me, but he's always busy and doesn't seem to have time to do a demo let alone teach me how to use the processor. I love the looks of it, for display purposes, but I'm not so thrilled about the knob controller. I think RF really didn't do themselves any favors by doing this instead of a digital remote control display, like the Audison Bit Controller.

I haven't had a chance to play with the Bit Ten or Ten D at all. But I had the Bit One and man was that complicated. So I think user interface for me is going to be difficult to learn.

I'm sure there are other units out there that will work for me. Matter of fact I'm going to do some research on them and see what I come up with.

But I could use some thoughts and suggestions here guys! What do you guys think?!

Is it worth the money?

Is it going to make that big a difference in my set up?

Does it essentially eliminate my head unit then since most of them all run off bluetooth now?

Thanks, I'll be back later.

Hey Scoot, I came to the conclusion that I don't need a HU either since I ALWAYS use my iPad and if I for whatever reason don't have it, I'm just set up another source on a processor and use my phone or something.

Anyways, I think you should STRONGLY consider the Bit Ten D.. Reason you want the "D" (see what I did there?) is because it has the controller. You can control volume, fade, sub, everything on that little controller and it would fit where ever you want, and since your tight on space, it'd help out alot..

You're gonna have to learn how to use whatever you buy anyways. And it will suck at first so you might as well buy what you want and just deal with the fact that learning will suck, anyways..

The bit ten D has basically all the tuning cApabilities of the bit 1, littler easier to use. I'm going to be getting one myself for this summer when I redo my blowthrough in my silverado.. I really think you should consider that bit ten man

Posted

Hey bro,....

Just opinions here...

I love processors. Love the control. Love the adjustability. Especially with my broad music taste.

Now, what one. The bit 10d (dude above is correct, get the one with the separate mountable controller) is a damn damn nice piece of gear.

And the .3 is as well. But, I've personally never heard a system with the .3.

Don't want to comment on something I've never even seen, but te reputation alone would lead you to have faith.

In short, I like using a processor. And dunno which direction to send you on buying one over the other.

Man, this post is worthless!!..

Your project is hella interesting and looking great though man.

Cheers and good luck bro ham.

Posted

Thanks guys. Kylar your post wasn't worthless, I appreciate your point of view and your opinion. It's why I posted it.

Yeah I had the Bit One with the controller and I loved the adjust ability at my fingertips and the 4 different setups at the push of a button etc. The ability to control the sub volume from there as well, thus eliminating the bass controller so to speak, and the cool blue lighting it had on it as well. One of the main problems I had with the Bit One was I became so damn overwhelmed with the software and setting it up. Not that it's a bad thing, because really I'm going to have to learn it like you guys say no matter what I get.

At this point I'd lean toward that Bit Ten D for the controller alone. From what I am seeing the interfacing is pretty similar between the 360 and the Bit. So I think either way it's going to take some patience and getting used to. Or a walk through by someone who can do so.

As far as systems that have them, Meade has his in his lexus and is getting killer reviews and while he's learned how to use it by now, his was set up by the Fosgate Guru's. CJ18 (Cody) has his too and before he spoke with Meade he was going to sell it cause it was "too complicated" to use. But then he spoke with Meade and it's brought a whole new realm, I think is what he told me, to tuning his system. So I have no doubts about the RF and it's abilities, especially from those two guys. Also Jon Rabe (skyhighaudio) has one and I could always go sit with him and he could help me. We've already talked about him tuning my system for me anyway, since he's been so involved from the beginning of this thing.

I'm not sure on the Fosgate and it's setting abilities, like the Bit Ten or One has the ability to set up 4 different settings, and you can have those at the push of a button on the controller. For example, if my kids were in the car, and I wanted the subs off, mid bass on but turned down lower than normal, I could set that up on button A. If I wanted a quieter set up at different frequency ranges, with subs on, I could set that up on button B. If I had rear fill for the kids, and they were watching a movie, needed low bass for effect, rear fill on, etc I could set that up on button C. And there's a button D too. Complete control. I don't know if the 360 has that ability. I have to research it more.

Next up is digital or analog. My tablet has the HDMI output which I can have going into my converter, which will give me a digital output via optical toslink whatever. I know the Bit Ten and One has this ability. Does the Fosgate? Upon further review it does have optical in. I'd have to consider if I want to utilize that as well. I couldn't without a processor.

Next up is how to do I get my hands on either of them? If I were to get the Bit Ten D, who's got em? Some thing with the 360. Do I want to spend that much coin on it, and spend it right now.

Do I want to give up my head unit and the radio? I'm sure I can get an app for radio, so if I did that I have to make sure it's going to work properly. If not it doesn't matter I guess I could listen to "more tamed" music while kids are present etc. All loaded on my tablet.

Ok i guess I have some homework to do. Thanks guys!

Posted

After a little more review, it appears that the 360.3 does in fact have 4 settings you can choose from like the bit one/ten, and it does have it on the controller knob, the right side knob.

The more I think about this processing, the more I'm leaning back towards a bit one or 360.3. I may end up putting rear fill in the car later on, and I'd like the ability to process that as well. So I may go one of those two routes. Makes me wish I'd have hung on to my BitOne I used to have. Damn!

Posted

Ok so a couple things happened today.

First, I'm waiting on a price for the 360.3. But I'm not 100% sure I'm going to go there yet.

Second, we FINALLY go the keys to the house today! WOOHOO!

20130118_124638.jpg

And of coarse I failed cause I was going to take pics of the shop that I'm going to be moving my stuff into, and I completely forgot. Oh well, I'll get them soon!

Then there was this. I was getting ready to walk out the door from work to go meet the Realtor at the house, and I got a call from the front desk. "The UPS guy is here, and you really aught to come up here". SO, up I went to find this!!

20130118_114306.jpg

20130118_114318.jpg

My first thought was AW FUCK my subs are gonna be trashed! It looks like someone dropped these things off the back of the ups truck! Then dragged them down the street! What has BROWN done for you!?!

So I had to go to the house and then came back and opened them up to see the damage. I notified the seller while I was gone to let him know what was up and he was pissed and said if there was damage to them he'll get it worked out for me etc. He was really cool about it. So I got back and opened them up to find this!

Box 1 - Styrofoam completely destroyed!

20130118_133403.jpg

Now to see what the sub looks like, and I was afraid to open the bag up!

20130118_133746.jpg

But to my surprise, there was no damage on the subs at all. The stuff on the upper right of the surround was already there and I knew about that. I'll get to that later.

20130118_133526.jpg

DAT ASS!!

20130118_133537.jpg

Box #2, Box 1 had this on it as well, I just had already taken it off.

20130118_133649.jpg

This one was very well filled and packed.

20130118_133656.jpg

This is with the sub out! Lots of packing peanuts and noodles!

20130118_133743.jpg

And to my surprise it was also in fine shape!

20130118_133807.jpg

Again DAT ASS!!

20130118_133822.jpg

The pair!

20130118_141321.jpg

20130118_141327.jpg

So here's the surround of the first sub. It has spray foam over spray on it. It doesn't look that terrible in person, but it does look bad. So I'm currently trying to figure out a way to clean it up. I was thinking about Great Stuff Work Wipes, and then came across this stuff called Mostenbockers Lift Off Caulk Silicone and Foam Sealant Remover.

20130118_164813.jpg

Dre is going to be kind enough to try it on a blown sub he has and tell me if it will ruin the surround or not. I can't imagine it will, but I don't really wanna take a chance. So I'll wait to hear from him!

So that's about it for today. Only thing I'm waiting on now is the D4700.

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members (See full list)

    • There are no registered users currently online
×
×
  • Create New...