CarAudioFab Posted February 25, 2013 Report Posted February 25, 2013 Hey everyone, I wanted to share with you my techniques for wiring and using techflex. I really enjoy using it to protect wiring and it does a great job of "cleaning up" the install. It's also great for revamping older wiring. Enjoy! -Mark Host of "CarAudioFabrication" - YouTube Car Audio Tutorial Channel Check out my forum section here on SMD for my builds and tutorial videos! Subscribe on YouTube: http://www.youtube.com/CarAudioFabrication
newls1 Posted February 25, 2013 Report Posted February 25, 2013 i dont get the point as of why you put wire loom over a single wire... IMO you didnt accomplish a better "looking" wire.. the heat shrink on ends in a given and should be done regardless. The best "looking" wire is one that is well hidden I love my staffie So anti FACEBOOK it isn't even funny
flarobbie Posted February 26, 2013 Report Posted February 26, 2013 i think it was a good idea. mabey not so much on the little wires, but to make the over-all look of the larger wires, and same type wires cleaner, it really did make it look cleaner. i would do it, but it would cost me like a thousand bucks to do all my wires!!
CarAudioFab Posted February 26, 2013 Author Report Posted February 26, 2013 i dont get the point as of why you put wire loom over a single wire... IMO you didnt accomplish a better "looking" wire.. the heat shrink on ends in a given and should be done regardless. The best "looking" wire is one that is well hidden This is well hidden, I couldn't agree more. -Mark Host of "CarAudioFabrication" - YouTube Car Audio Tutorial Channel Check out my forum section here on SMD for my builds and tutorial videos! Subscribe on YouTube: http://www.youtube.com/CarAudioFabrication
flarobbie Posted February 26, 2013 Report Posted February 26, 2013 plus the wire is protected a little more with the covering. this can help out in the long run
Recommended Posts
Archived
This topic is now archived and is closed to further replies.