deathcards Posted February 15, 2014 Report Share Posted February 15, 2014 Edited the title, looking for deals on rods and pistons. Crank should be OK at my power goal. Looking at H-beam rods, ill never be in the power range that needs I-beams. Pistons stock bore and flat top. well i don't have much going on for the next couple hours i could help a bit skar sk2500.1 0 gauge power and ground kunukonceptz alpine HUvxi65 components on BA gt-275new build log -> http://www.stevemeadedesigns.com/board/topic/150642-project-d-kon-deathcards-build-log/#entry2148821 2 x-15 sundowns singer alt, odyssey bat, and maxwell ultra caps Link to comment Share on other sites More sharing options...
TRTC360 Posted February 15, 2014 Report Share Posted February 15, 2014 Edited the title, looking for deals on rods and pistons. Crank should be OK at my power goal. Looking at H-beam rods, ill never be in the power range that needs I-beams. Pistons stock bore and flat top. not trying to be a dick, but why the hell would you do all that work only to run a stock crank? '93 Firebird Formula V8 H/U- Kenwood eXcelon KDC-X395 Mids/Highs Amp- Hifonics ZXI80.4 Wiring-KNU RCA's, Speaker Wire, And Two Runs Of Trystar 1/0 G34 Red Top and a 180amp Ford Alternator www.youtube.com/TRTC360 Link to comment Share on other sites More sharing options...
OrionStang Posted February 15, 2014 Author Report Share Posted February 15, 2014 Edited the title, looking for deals on rods and pistons. Crank should be OK at my power goal. Looking at H-beam rods, ill never be in the power range that needs I-beams. Pistons stock bore and flat top. not trying to be a dick, but why the hell would you do all that work only to run a stock crank? Why would I change it when its good for the power goal im looking at? I honestly don't need to do pistons either, as long as the tune is straight. Why don't you ask Ford why their parts aren't on consistent power ratings. SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
deathcards Posted February 15, 2014 Report Share Posted February 15, 2014 are you trying to stay with the 4.6l and i tried to google it but couldn't figure out where to get the specs for the stock bore and stroke for your engine skar sk2500.1 0 gauge power and ground kunukonceptz alpine HUvxi65 components on BA gt-275new build log -> http://www.stevemeadedesigns.com/board/topic/150642-project-d-kon-deathcards-build-log/#entry2148821 2 x-15 sundowns singer alt, odyssey bat, and maxwell ultra caps Link to comment Share on other sites More sharing options...
OrionStang Posted February 15, 2014 Author Report Share Posted February 15, 2014 This will go nowhere, can see it now. Mods please lock it. SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.